Embedding fiber optics in metal components could enable new capabilities such as active monitoring of spatially distributed strain. Ultrasonic additive manufacturing is a suitable technique for embedding fiber optics because it allows fibers to be embedded in metals without melting and without the use of epoxy. However, for harsh environments that could have high temperatures or high radiation doses, traditional polymer-coated fibers cannot survive for extended periods of time. This work demonstrates successful embedding of commercially available copper-, nickel-, and aluminum-coated fibers into aluminum without any observable damage to the fiber. Copper-coated fibers embedded in copper show adequate light transmission, although residual strain could not be resolved. With further processing improvements, fibers embedded in copper or other hightemperature materials could enable even higher temperature operation. Optical transmission and spatially distributed strain were measured in the fibers embedded in aluminum. Measurements were taken after embedding and during heating to temperatures greater than 500 °C. Within the embedded region, both the copper-and aluminum-coated fibers showed strain that matched the expected strain in the surrounding aluminum matrix during heating. This suggests a strong interfacial bond strength that exceeds the maximum estimated fiber strain of 1.2% (871 MPa tensile stress). This demonstration of embedded fibers that can survive high temperatures and remain bonded to the metal matrix is the first step toward embedded fiber optic sensors for harsh environment applications.
Fiber optic sensors have long been considered for use in structural health monitoring of components because of their small size, high accuracy, and their ability to perform spatially distributed strain measurements when embedded within a component or on its surface. The typical method for transferring strain from the component to the fiber is to use an epoxy, which may not survive extended exposure to high temperatures, thus necessitating a more elaborate technique to embed the fibers. This work represents a first step towards using additive manufacturing techniques to embed fiber optic sensors on stainless steel components for hightemperature strain monitoring, including quantification of the differential thermal strains that develop between the fiber and the steel substrate. Copper-coated optical fibers were embedded in nickel layers on top of a stainless steel substrate using an ultrasonic additive manufacturing technique. The embedded fibers showed minimal signal attenuation and clear compressive strain after embedding. Heating the embedded fibers in steps to temperatures of 300 °C-400 °C resulted in measured strains with values between the expected thermal strain in stainless steel and nickel. Finite element simulations confirm the measured strain values and show that the thermal strain depends on the thickness of the nickel layers deposited on top of the stainless steel substrate. While the fibers failed before reaching temperatures of 500 °C, it is suspected that these failures occurred due to a combination of (1) the lack of strain relief, (2) the hightemperature oxidation of the fiber's copper coating, and (3) improper sizing of the machined channel in which the fiber is placed prior to embedding. If proper coating selection and sizing of the channel can prevent the failures observed in this work, the next step would be to monitor strain during mechanical loading at high temperatures.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.