Poly(2-alkyl-1,3-oxazoline)s (alkyl = methyl, ethyl) with terminal quarternary ammonium groups were synthesized. It could be shown by NMR and ESI-MS that the termination of the living polymerization with N,N-dimethylalkyl(butyl to hexadecyl)amines was quantitative. The novel functions were investigated regarding their antimicrobial potential toward the bacterium Staphylococcus aureus revealing that only quarternary ammonium functions with 12 and more carbons are antibacterial. Using a novel bifunctional initiator, 3-[(tert-butoxycarbonyl)amino]benzyl-p-toluenesulfonate, poly(oxazoline) with a primary amino group at the starting end and an antimicrobial function at the terminal could be synthesized, as confirmed by NMR and ESI-MS measurements. Comparing the bioactivity of polymers with different functions at the starting end and terminated with dimethyldodecylamine revealed that the starting group has a great effect on the antibacterial properties of the distant terminal. The minimal inhibitory concentrations varied from 0.1 mM for polymer derivatives with a BOC-NH-phenyl starting group to 4 mM for poly(oxazoline)s with a free primary amine at the starting end.

The antimicrobial activity of poly(alkyloxazoline) telechelics with one quaternary N,N-dimethyldodecylammonium (DDA) end group was found to be greatly controlled by the non-bioactive distal end group, the so-called satellite group. In systematic investigations, the nature of the latter groups was varied to explore the mechanism of the satellite effect. To this end, poly(2-alkyl-1,3-oxazoline)s (alkyl = ethyl, methyl) with a DDA-group at the terminating end and varying alkyl, aminoalkyl, and polyphenyloxazoline block satellite groups, have been synthesized. Poly(oxazoline) derivatives with polydispersity indices of 1.06-1.20 and molecular weights from 2,200 to 12,800 g . mol(-1) could be obtained. The macromolecular structures have been confirmed by NMR spectroscopy and ESI-MS measurements. The polymers were investigated with regard to their antibacterial efficiency towards the Gram-positive bacterium Staphylococcus aureus and the Gram-negative bacterium Escherichia coli. It was found that the introduction of alkyl chain satellites of 4-10 carbon atoms in length afforded antimicrobial activity of the polymers against both microbes that was about 2-3 times higher than that of the well-known structurally comparable low molecular weight biocide, dodecyltrimethylammonium chloride (DTAC). Based on the antimicrobial effects of the investigated polymers, a mechanism for the satellite effect was proposed.

No abstract

The antimicrobial activity of poly(2-methyl-1,3-oxazoline)s (PMOX) with the antimicrobial N,N-dimethyldodecylammonium (DDA) end group is greatly dependent on the nature of the group at the distal end of the polymer, the satellite group. Three comparable PMOX with a DDA end group and different satellite groups (methyl, decyl, hexadecyl) were investigated with respect to the reasons for the huge differences in their biocidal behavior. Static light scattering (SLS) and pulsed field gradient diffusion NMR measurements revealed that the samples show comparable aggregation conduct, thus, not being responsible for the varying biological activity. Experiments using different liposomal systems as models for bacterial cell membranes have been performed. It was found that differential interactions between the respective polymers and the phospholipid membranes constitute the reason for the varying effectiveness observed in antimicrobial susceptibility determinations.

Although modern dental repair materials show excellent mechanical and adhesion properties, they still face two major problems: First, any microbes that remain alive below the composite fillings actively decompose dentin and thus, subsequently cause secondary caries. Second, even if those microbes are killed, the extracellular proteases such as MMP, remain active and can still degrade collagenousdental tissue. In order to address both problems, a poly(2-methyloxazoline) with a biocidal quaternary ammonium and a polymerizable methacrylate terminal was explored as additive for a commercial dental adhesive. It could be demonstrated that the adhesive rendered the adhesive contact-active antimicrobial against S. mutans at a concentration of only 2.5 wt% and even constant washing with water for 101 days did not diminish this effect. Increasing the amount of the additive to 5 wt% allowed killing S. mutans cells in the tubuli of bovinedentin upon application of the adhesive. Further, the additive fully inhibited bacterial collagenase at a concentration of 0.5 wt% and reduced human recombinant collagenase MMP-9 to 13% of its original activity at that concentration. Human MMPs naturally bound to dentin were inhibited by more than 96% in a medium containing 5 wt% of the additive. Moreover, no adverse effect on the enamel/dentine shear bond strength was detected in combination with a dental composite.