The conventional manufacturing methods for fabricating orthotic and prosthetic (O&P) devices have been in practice for a very long time. Recently, O&P service providers have started exploring different advanced manufacturing techniques. The objective of this paper is to perform a mini review on recent progress in the use of polymer-based additive manufacturing (AM) for O&P devices and to gather insights from the O&P professionals on the current practices and technologies and on the prospect of using AM techniques in this field. First, scientific articles on AM for O&P devices were studied. Then, twenty-two (22) interviews were conducted with O&P professionals from Canada. The primary focus was on five key areas: cost, material, design and fabrication efficiency, structural strength, functionality, and patient satisfaction. The cost of manufacturing the O&P devices using AM techniques is lower as compared to the conventional methods. O&P professionals expressed their concern over the materials and structural strength of the 3D-printed prosthetic devices. Published articles report comparable functionality and patient satisfaction for both O&P devices. AM also greatly improves design and fabrication efficiency. However, due to a lack of qualification standards for 3D printed O&P devices, 3D printing is being embraced more slowly in the O&P business than in other industries.
Copper, due to its high thermal and electrical conductivity, is used extensively in many industries such as electronics, aerospace, etc. In the literature, researchers have utilized different additive manufacturing (AM) techniques to fabricate parts with pure copper; however, each technique comes with unique pros and cons. Among others, material extrusion (MEX) is a noteworthy AM technique that offers huge potential to modify the system to be able to print copper parts without a size restriction. For that purpose, copper is mixed with a binder system, which is heated in a melt chamber and then extruded out of a nozzle to deposit the material on a bed. The printed part, known as the green part, then goes through the de-binding and sintering processes to remove all the binding materials and densify the metal parts, respectively. The properties of the final sintered part depend on the processing and post-processing parameters. In this work, nine published articles are identified that focus on the 3D printing of pure copper parts using the MEX AM technique. Depending on the type of feedstock and the feeding mechanism, the MEX AM techniques for pure copper can be broadly categorized into three types: pellet-fed screw-based printing, filament-fed printing, and direct-ink write-based printing. The basic principles of these printing methods, corresponding process parameters, and the required materials and feedstock are discussed in this paper. Later, the physical, electrical, and mechanical properties of the final parts printed from these methods are discussed. Finally, some prospects and challenges related to the shrinkage of the printed copper part during post-processing are also outlined.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.