Silver nanoparticle suspensions were synthesized by chemical reduction method using a formaldehyde reductant. Polyvinyl pyrrolidone (PVP) of two different molecular weights (M.W.=8,000 and 29,000) was used as a stabilizer for the suspensions. PVP of a smaller molecular weight could produce silver suspensions of nanoparticle size around 20 nm. Water-based conductive silver inks with different silver concentrations were prepared and tested for suitability for screen printing. We have successfully printed silver metal lines on glass substrates using a 400 mesh screen-mask with 60wt.% silver ink prepared in this study. Curing at a low temperature of 200 o C for an hour was found sufficient to reach the lowest resistivity value with the synthesized ink. For a line with a width and thickness of 0.5 mm and 2.12 μm, respectively, it exhibited a resistivity of 3.3×10 −5 Ω·cm, which could serve as conducting lines for various electronic applications.

No abstract

No abstract

Zinc oxide thin films have been prepared via a sol–gel process. The influence of annealing temperature on the structural and optical properties of the ZnO thin films has been investigated. The prepared ZnO thin films had a polycrystalline hexagonal wurtzite structure with no preferred orientation. The annealing temperature had a great effect on the optical properties of the ZnO thin films: the optical band gap became narrow due to the increase in crystallite size and the reduction in amorphous phase amount with increasing annealing temperature. Absorption or desorption of oxygen in the annealing process caused the observed yellow or green emission. (© 2006 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

No abstract

No abstract

No abstract

No abstract