No abstract

No abstract

Traditionally, using a long post can cause progressive removal of the root structure, complicate the ability to re-treat the tooth if necessary and make it difficult to apply an adhesive bonding agent into the root canal. It is unclear if a shorter post length can be applied when a light translucent glass fibre post and adhesive resin cement are used. The aim of this study was to evaluate the biomechanical performance of endodontically treated teeth restored with three post materials, glass-fibre, stainless steel and cast-nickel chromium posts and cores of different lengths of 7, 10 and 13 mm. A 3D finite element analysis model of the maxillary central incisor was constructed. An occlusal load of 300 N was applied to a node at the palatal surface of the crown at 45 degrees to the long axis of the tooth. von Mises stress analyses were carried out in three regions. Simulated data were collected for plotting various pattern graphics and conducting statistical tests. The pattern graphics showed that when the post length changed from 13 to 7 mm, the stress patterns were even and flat in all fibre-post groups, while the stress patterns of the metal-post groups showed an M-shaped peak and trough. Statistical tests showed that the shorter fibre post was superior to the longer metal post in some situations. Within the limitations of this study, it was concluded that when a metal post is used, the post should be as long as possible, while the biomechanical performance of a glass-fibre post combined with a composite resin core was less sensitive to post length.

Three-dimensional, anisotropic finite element models were executed to investigate the biomechanical effects of in-line and offset placements of implants on implant-supported partial prostheses. Three implant placements of finite element models were created: in-line, buccal offset and lingual offset placements. The mesh models of a cadaver mandibular segment and a three-united crown containing the 2nd premolar, the 1st molar and the 2nd molar were constructed by computer tomography images. The material properties of mandible were applied as transversely isotropic and linearly elastic. Two loading modes (100N), vertical and oblique, were evaluated in all models. Insignificant difference was observed in implant stresses between the in-line and offset placements under the vertical loading mode. Under the oblique loading, however, the offset placement decreased the implant stress by a maximum of 17%. The maximum stress at cortical bone and trabecular bone around each implant did not show conspicuous difference between the in-line and offset placements. This study demonstrated the mechanisms of how stresses were distributed between the in-line and offset placements. Even though the offset placements showed the benefit of decreasing implant stresses, justified from the bone stress the offset placements provided no advantage for the stress decreasing over the in-line placement.

No abstract