No abstract

In this study, a new type of field-effect transistor (FET)-based biosensor is demonstrated to be able to overcome the problem of severe charge-screening effect caused by high ionic strength in solution and detect proteins in physiological environment. Antibody or aptamer-immobilized AlGaN/GaN high electron mobility transistors (HEMTs) are used to directly detect proteins, including HIV-1 RT, CEA, NT-proBNP and CRP, in 1X PBS (with 1%BSA) or human sera. The samples do not need any dilution or washing process to reduce the ionic strength. The sensor shows high sensitivity and the detection takes only 5 minutes. The designs of the sensor, the methodology of the measurement, and the working mechanism of the sensor are discussed and investigated. A theoretical model is proposed based on the finding of the experiments. This sensor is promising for point-of-care, home healthcare, and mobile diagnostic device.Field-effect transistors (FETs) attract great interest for biomolecular detection, due to their high sensitivity, small size, and label-free detection, which are suitable for point-of-care or personal homecare devices. Either planar or nanowire FET-based biosensors have been widely studied using various materials, such as Si 1 , GaN 2 , carbon nanotube (CNT) 3 , or graphene oxide 4 . Conventionally, FET-based biosensors with receptors (ex. antibody) immobilized on the gate region above the active channel of the FETs face an intrinsic issue, which is the severe charge screening effect in high ionic strength solutions, such as in serum or blood samples, leading to low sensitivity for direct detection of protein in the physiological environment. The Debye length in physiological salt environment (1X PBS) is near 0.7 nm, which is much smaller than the size of a regular IgG antibody (5~10 nm) 5 . In order to effectively detect proteins with receptor-immobilized FETs, the electrical measurements are usually conducted in diluted buffer solutions, such as in 0.1X PBS or 0.01X PBS, where the Debye lengths as 2.4 nm and 7.4 nm, respectively 1,6,7 . However, diluted ionic strength solution may cause the change in protein structure, resulting in the loss of protein activity, and the binding affinity as well. For most biological reactions, which occur in physiological high salt environment, a biosensor that can be used directly with physiological samples is much favored. Besides, an additional washing process is needed for conventional FET-based biosensors to remove the unbound antigen before electrical measurement, which also increases the complexity of the whole sensor system. Therefore, direct detection of the target protein in physiological sample is very demanding.Previously, several groups have reported that conventional FET-based biosensors can effectively detect proteins in physiological salt environment, using alternative current (AC) signals in drain-source voltage (V ds ), in conjunction with a reference electrode, in a relatively high frequency [8][9][10][11] . The better sensitivity of AC signals compared to that o...

No abstract

A large, ultra-black, efficient and cost-effective dye-sensitized solar module reaches an overall efficiency of ∼12% under 1000 lux of T5 fluorescent light.

A series of anthracene-based organic dyes were prepared via cost-effective synthetic procedures for dye-sensitized cell application. UV−visible and fluorescent spectra, electrochemical properties, and photovoltaic performance of the dyes were studied. Under one sun (100 mW/cm 2 ), the AN-3 small cell outperforms others in the series. Under a dim light condition, the AN-3 modules showed PCE comparable to that of the Z907 modules. After optimizing the synthetic procedure, we found that AN-3 can be manufactured at a fairly low price.