To improve the safety of HMX, a two‐dimensional (2D) graphene oxide (GO) was introduced to HMX by the solventnonsolvent method. The morphology, composition, thermal decomposition characteristic were characterized by scanning electron microscopy (SEM), X‐ray diffraction (XRD), X‐ray photoelectron spectroscopy (XPS), thermogravimetry (TG) and differential scanning calorimetry (DSC). Compared to the previous reports, GO sheets exhibited better desensitizing effect than [60]Fullerene and CNTs. When 2.0 wt‐% GO sheets were added, the impact sensitivity of raw HMX decreased from 100 to 10 %, and the friction sensitivity reduced from 100 to 32 %. The DSC results proved that GO sheets were compatible with HMX. In addition, by determining the thermal decomposition kinetic parameters of the samples, it was found that the activation energy (Ea) of HMX with 2.0 wt‐% GO increased by 23.5 kJ mol−1, suggesting that GO sheets could improve the thermal stability of HMX.

No abstract

No abstract

No abstract

The shock sensitivities of plastic bonded explosives were studied with a thin flyer impact test by using two types of pressed RDX. The thin flyer, driven by an electrically exploding plasma, exerts a short‐duration, high‐pressure pulse to the samples to trigger a shock‐to‐detonation process. It was found that the duration and magnitude of the incident shock strongly influence the dominant mode of hot‐spot formation, promoting a fast pore collapsing mechanism while suppressing other slower shear or friction mechanisms, as proposed by Chakravarty et al. [1]. The pressed PBX based on reduced sensitivity RDX had higher shock threshold pressure, compared to the pressed PBX based on commercial RDX. The difference was observed even with a certain portion of external extragranular defects. It is postulated that the internal crystal defects are more efficient than the external porosity in terms of the rapid reaction of hot spots.