Even for employed problem drinkers who are not abusing drugs and who have no serious medical problems, an initial referral to AA alone or a choice of programs, although less costly than inpatient care, involves more risk than compulsory inpatient treatment and should be accompanied by close monitoring for signs of incipient relapse.

No abstract

Light emitting diodes, LEDs, historically have been used for indicators and produced low amounts of heat. The introduction of high brightness LEDs with white light and monochromatic colors have led to a movement towards general illumination. The increased electrical currents used to drive the LEDs have focused more attention on the thermal paths in the developments of LED power packaging. The luminous efficiency of LEDs is soon expected to reach over 80 lumens/W, this is approximately 6 times the efficiency of a conventional incandescent tungsten bulb. Thermal management for the solid-state lighting applications is a key design parameter for both package and system level. Package and system level thermal management is discussed in separate sections. Effect of chip packages on junction to board thermal resistance was compared for both SiC and Sapphire chips. The higher thermal conductivity of the SiC chip provided about 2 times better thermal performance than the latter, while the under-filled Sapphire chip package can only catch the SiC chip performance. Later, system level thermal management was studied based on established numerical models for a conceptual solid-state lighting system. A conceptual LED illumination system was chosen and CFD models were created to determine the availability and limitations of passive air-cooling.

No abstract

No abstract

Velocity distributions for Ar atoms scattering from a clean, polycrystalline tungsten surface have been measured for a wide range of incident supersonic beam energies 300 K < (1/2) m〈v2〉/k<2000 K, and surface temperatures 350 K<Ts<1900 K. This work studies directly the nature of the scattering process of an intermediate mass atom on a clean metal surface over a very wide range of conditions. Direct inelastic scattering involving a single encounter of the gas atom with the surface is the most important process. No distinct elastic or quasielastic scattering occurs. Only at the lowest temperatures is a trapping–desorption scattering process observed. The direct inelastic scattering process is characterized by the linear proportional relationship 〈KEe〉=0.83 〈KEi〉+0.20 〈KETs〉 over the entire range of energies and temperatures for 45° angle of incidence and observation in the specular direction (KEe, KEi, and KETs are the kinetic energy of the exiting Ar, the incident Ar, and the Ar in equilibrium at the surface temperature, respectively). The proportionality relationship is nearly the same for observation in the normal direction. The collision-caused spread in velocities is linearly proportional to the surface temperature, and substantially independent of incident energy. Tangential momentum accommodation is also discussed.

Dendrometer bands are common tools used when accurate measurement of tree-diameter growth or basal-area growth is desired. This common type of dendrometer consists of a metal band placed around the stem of the tree with reading scales scribed on the overlapping portions of the band. Homemade dendrometer bands can be made and installed efficiently and economically. Complete instructions together with a description of materials necessary for the construction and placement of dendrometer bands are presented. Evaluation of dendrometer bands in a field setting is also discussed. North. J. Appl. For. 3:73-75, June 1986.

No abstract