Presented here, is an extensive 35 parameter experimental data set of a cylindrical 21700 commercial cell (LGM50), for an electrochemical pseudo-two-dimensional (P2D) model. The experimental methodologies for tear-down and subsequent chemical, physical, electrochemical kinetics and thermodynamic analysis, and their accuracy and validity are discussed. Chemical analysis of the LGM50 cell shows that it is comprised of a NMC 811 positive electrode and bi-component Graphite-SiOx negative electrode. The thermodynamic open circuit voltages (OCV) and lithium stoichiometry in the electrode are obtained using galvanostatic intermittent titration technique (GITT) in half cell and three-electrode full cell configurations. The activation energy and exchange current coefficient through electrochemical impedance spectroscopy (EIS) measurements. Apparent diffusion coefficients are estimated using the Sand equation on the voltage transient during the current pulse; an expansion factor was applied to the bi-component negative electrode data to reflect the average change in effective surface area during lithiation. The 35 parameters are applied within a P2D model to show the fit to experimental validation LGM50 cell discharge and relaxation voltage profiles at room temperature. The accuracy and validity of the processes and the techniques in the determination of these parameters are discussed, including opportunities for further modelling and data analysis improvements.
(2015) Voltammetric scanning electrochemical cell microscopy : dynamic imaging of hydrazine electro-oxidation on platinum electrodes. Analytical Chemistry Permanent WRAP url: http://wrap.warwick.ac.uk/67791 Copyright and reuse:The Warwick Research Archive Portal (WRAP) makes this work of researchers of the University of Warwick available open access under the following conditions. Copyright © and all moral rights to the version of the paper presented here belong to the individual author(s) and/or other copyright owners. To the extent reasonable and practicable the material made available in WRAP has been checked for eligibility before being made available.Copies of full items can be used for personal research or study, educational, or not-forprofit purposes without prior permission or charge. Provided that the authors, title and full bibliographic details are credited, a hyperlink and/or URL is given for the original metadata page and the content is not changed in any way. Publisher's statement:This document is the Accepted Manuscript version of a Published Work that appeared in final form in Analytical Chemistry copyright © American Chemical Society after peer review and technical editing by the publisher. To access the final edited and published work see link to Published Work, http://pubs.acs.org/page/policy/articlesonrequest/index.html]The version presented here may differ from the published version or, version of record, if you wish to cite this item you are advised to consult the publisher's version. Please see the 'permanent WRAP url' above for details on accessing the published version and note that access may require a subscription. Abstract:Voltammetric scanning electrochemical cell microscopy (SECCM) incorporates cyclic voltammetry measurements in the SECCM imaging protocol, by recording electrochemical currents in a wide potential window at each pixel in a map. This provides much more information compared to traditional fixed potential imaging. Data can be represented as movies (hundreds of frames) of current (over a surface region) at a series of potentials and are highly revealing of subtle variations in electrode activity. Furthermore, by combining SECCM data with other forms of microscopy, e.g. scanning electron microscopy and electron backscatter diffraction data, it is possible to directly relate the current-voltage characteristics to spatial position and surface structure. In this work we use a 'hopping mode', where the SECCM pipet probe is translated towards the surface at a series of positions until meniscus contact. Small amounts of residue left on the surface, upon probe retraction, demark the precise area of each measurement. We use these techniques to study hydrazine oxidation on a polycrystalline platinum substrate in air and in a deaerated environment. In both cases, the detected faradaic current shows a structural dependence on the surface crystallographic orientation. Significantly, in the presence of oxygen (aerated solution) the electrochemical current decreases strongly for alm...
The influence of electrode surface structure on electrochemical reaction rates and mechanisms is a major theme in electrochemical research, especially as electrodes with inherent structural heterogeneities are used ubiquitously. Yet, probing local electrochemistry and surface structure at complex surfaces is challenging. In this paper, high spatial resolution scanning electrochemical cell microscopy (SECCM) complemented with electron backscatter diffraction (EBSD) is demonstrated as a means of performing ‘pseudo-single-crystal’ electrochemical measurements at individual grains of a polycrystalline platinum electrode, while also allowing grain boundaries to be probed. Using the Fe2+/3+ couple as an illustrative case, a strong correlation is found between local surface structure and electrochemical activity. Variations in electrochemical activity for individual high index grains, visualized in a weakly adsorbing perchlorate medium, show that there is higher activity on grains with a significant (101) orientation contribution, compared to those with (001) and (111) contribution, consistent with findings on single-crystal electrodes. Interestingly, for Fe2+ oxidation in a sulfate medium a different pattern of activity emerges. Here, SECCM reveals only minor variations in activity between individual grains, again consistent with single-crystal studies, with a greatly enhanced activity at grain boundaries. This suggests that these sites may contribute significantly to the overall electrochemical behavior measured on the macroscale.
The scanning droplet-based technique, scanning electrochemical cell microscopy (SECCM), combined with electron backscatter diffraction (EBSD), is demonstrated as a powerful approach for visualizing surface structure effects on the rate of the oxygen reduction reaction (ORR) at polycrystalline platinum electrodes. Elucidating the effect of electrode structure on the ORR is of major interest in connection to 10 electrocatalysis for energy-related applications. The attributes of the approach herein stem from: (i) the ease with which the polycrystalline substrate electrode can be prepared; (ii) the wide range of surface character open to study; (iii) the possibility of mapping reactivity within a particular facet (or grain), in a pseudo-single crystal approach, and acquiring a high volume of data as a consequence; (iv) the ready ability to measure the activity at grain boundaries; and (v) an experimental arrangement (SECCM) that 15 mimics the three-phase boundary in low temperature fuel cells. The kinetics of the ORR was analyzed and a finite element model was developed to explore the effect of the three-phase boundary, in particular to examine pH variations in the droplet and the differential transport rates of the reactants and products. We have found a significant variation of activity across the platinum substrate, inherently linked to the crystallographic orientation, but do not detect any enhanced activity at grain boundaries. Grains with 20 (111) and (100) contributions exhibit considerably higher activity than those with (110) and (100) contributions. These results, which can be explained by reference to previous single crystal measurements, enhance our understanding of ORR structure-activity relationships on complex high-index platinum surfaces, and further demonstrate the power of high resolution flux imaging techniques to visualize and understand complex electrocatalyst materials.
The isoflavonoid genistein was found to be a better antioxidant than the isomeric flavonoid apigenin in phosphatidyl liposomes at pH 7.4. The higher antioxidation activity of genistein compared with apigenin is in agreement with its lower oxidation potential (0.73 vs 0.86 V as determined by cyclic voltammetry in aqueous solution of pH= 7.4), lower dissociation enthalpy (87.03 vs 87.88 kcal mol(-1) as calculated for the more reducing 4'-hydroxyl group), and higher radical scavenging capacity in the TEAC assay. On the basis of quantum mechanical calculations for genistein and apigenin in comparison with the flavonoid naringenin and the isoflavonoids puerarin, daidzein, and equol, a lower dipole moment and a larger deviation for the A-to-B dihedral angle from coplanarity (39.3 degrees for genistein, 18.5 degrees for apigenin) are suggested to be important for the increased antioxidant efficiency at water/lipid interfaces among (iso) flavonoids with an equal number of phenolic groups.
Hydroxyl radical reacts readily with β-carotene following submicrosecond laser photolysis of N-hydroxypyridine-2(1H)-thione (N-HPT) as a "photo-Fenton" reagent generating hydroxyl and thiyl radicals in acetonitrile:tetrahydrofuran (4:1, v/v) solution. On the basis of spectral evidence, and supported by kinetic considerations and thermodynamic calculations, a short-lived transient species, detected by time-resolved absorption spectroscopy with an absorption maximum at ∼750 nm and a lifetime of ∼150 ns at 25 °C under anaerobic conditions, is suggested to be the long-sought neutral β-carotene radical formed by hydrogen-atom abstraction. The transient spectrum is different from the spectra of the β-carotene radical cation (∼1000 nm absorption maximum with a millisecond lifetime), the β-carotene radical adducts (∼520 nm, several microsecond lifetime), the β-carotene radical cation ion pair (∼750 nm, several hundred microsecond lifetime), and the β-carotene radical anion (∼880 nm, a few tens of microsecond lifetime). In parallel, β-carotene reacts with the thiyl radical to yield a sulfur radical adduct with absorption maximum at ∼520 nm with a lifetime of 3.0 μs. For astaxanthin and canthaxanthin, the reaction with the thiyl radical dominates and the neutral radical is hardly formed in agreement with the less reducing properties of these 4,4'-diketo carotenoids without the reactive 4,4'-hydrogens.
Electron transfer to radical cations of beta-carotene, zeaxanthin, canthaxanthin, and astaxanthin from each of the three acid/base forms of the diphenolic isoflavonoid daidzein and its C-glycoside puerarin, as studied by laser flash photolysis in homogeneous methanol/chloroform (1/9) solution, was found to depend on carotenoid structures and more significantly on the deprotonation degree of the isoflavonoids. None of the carotenoid radical cations reacted with the neutral forms of the isoflavonoids while the monoanionic and dianionic forms of the isoflavonoids regenerated the oxidized carotenoid. Electron transfer to the beta-carotene radical cation from the puerarin dianion followed second order kinetics with the rate constant at 25 degrees C k(2) = 5.5 x 10(9) M(-1) s(-1), zeaxanthin 8.5 x 10(9) M(-1) s(-1), canthaxanthin 6.5 x 10(10) M(-1) s(-1), and astaxanthin 11.1 x 10(10) M(-1) s(-1) approaching the diffusion limit and establishing a linear free energy relationship between rate constants and driving force. Comparable results found for the daidzein dianion indicate that the steric hindrance from the glucoside is not important suggesting the more reducing but less acidic 4'-OH/4'-O(-) as electron donors. On the basis of the rate constants obtained from kinetic analyses, the keto group of carotenoids is concluded to facilitate electron transfer. The driving force was estimated from oxidation potentials, as determined by cyclic-voltametry for puerarin and daidzein in aqueous solutions at varying pH conditions, which led to the standard reduction potentials E degrees = 1.13 and 1.10 V versus NHE corresponding to the uncharged puerarin and daidzein. For pH > pK(a2), the apparent potentials of both puerarin and daidzein became constants and were E degrees = 0.69 and 0.65 V, respectively. Electron transfer from isoflavonoids to the carotenoid radical cation, as formed during oxidative stress, is faster for astaxanthin than for the other carotenoids, which may relate to astaxanthins more effective antioxidative properties and in agreement with the highest electron accepting index of astaxanthin.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.