Light energy is an important factor for plant growth. In regions where the natural light source (solar radiation) is not sufficient for growth optimization, additional light sources are being used. Traditional light sources such as high pressure sodium lamps and other metal halide lamps are not very efficient and generate high radiant heat. Therefore, new sustainable solutions should be developed for energy efficient greenhouse lighting. Recent developments in the field of light source technologies have opened up new perspectives for sustainable and highly efficient light sources in the form of LEDs (light-emitting diodes) for greenhouse lighting. This review focuses on the potential of LEDs to replace traditional light sources in the greenhouse. In a comparative economic analysis of traditional vs. LED lighting, we show that the introduction of LEDs allows reduction of the production cost of vegetables in the long-run (several years), due to the LEDs' high energy efficiency, low maintenance cost and longevity. In order to evaluate LEDs as a true alternative to current lighting sources, species specific plant response to different wavelengths is discussed in a comparative study. However, more detailed scientific studies are necessary to understand the effect of different spectra (using LEDs) on plants physiology. Technical innovations are required to design and realize an energy efficient light source with a spectrum tailored for optimal plant growth in specific plant species.

Photodarkening of Yb-doped aluminosilicate fibers by continuous wave 488 nm irradiation was investigated. The irradiation induced significant excess loss in the UV-visible spectroscopy (VIS) region in Yb-doped aluminosilicate fibers while pure aluminosilicate fibers showed negligible induced loss. Ultraviolet-VIS-near-infrared spectroscopy revealed an absorption peak at 220 nm in unexposed Yb-doped aluminosilicate fiber preforms. The observed peak was attributed to Yb-associated oxygen deficiency centers (ODCs) and proposed as a precursor of the photodarkening. The proposed model was supported by measurements on oxygen-loaded Yb-doped aluminosilicate fibers. In these, the photodarkening could be significantly reduced, which we attribute to a smaller number of ODCs following oxygen loading.

Contemporary white light-emitting diodes (LEDs) are much more efficient than compact fluorescent lamps and hence are rapidly capturing the market for general illumination. LEDs are also replacing halogen lamps or even newer xenon based lamps in automotive headlamps. Because laser diodes are inherently much brighter and often more efficient than corresponding LEDs, there is great research interest in developing laser diode based illumination systems. Operating at higher current densities and with smaller form factors, laser diodes may outperform LEDs in the future. This article reviews the possibilities and challenges in the integration of visible laser diodes in future illumination systems.

Dermoscopy systems that do not require direct skin contact open up the possibility to overcome limitations of established dermoscopes and promote application of this diagnostic tool beyond skin cancer screening. In this work, we present a non-contact remote digital dermoscope with large field of view, high resolution and true color imaging. We report preliminary clinical results for imaging of melanocytic nevi and two common inflammatory skin diseases, psoriasis and lichen ruber planus, obtained in non-contact mode demonstrating the potential of this method for skin cancer screening and for diagnosis of inflammatory disease. In the future, the system can be applied for whole-body automated cancer screening and support diagnostics of inflammatory skin diseases in the form of a hand-held device.

Gravitational wave detectors require linearly polarized single-frequency laser sources with a high fractional TEM 00 mode content. We investigated the modal decomposition of a polarization maintaining photonic crystal fiber with a mode field diameter of 29 µm, operating in a single-frequency master-oscillator power-amplifier scheme, with respect to the TEM nm modes. Low degradation of the beam quality with increasing pump power could be observed, while a maximum power in the TEM 00 mode of 203 W was achieved.

High power single frequency, single mode, linearly polarized laser output at the 1 μm regime is in demand for the interferometric gravitational wave detectors (GWDs). A robust single frequency solid state master oscillator power amplifier (MOPA) is a promising candidate for such applications. We present a single frequency solid state multistage MOPA system delivering 177 W of linearly polarized output power at 1 μm with 83.5% TEM(00) mode content.

We propose an architecture with a remote phosphor-based modular and compact light-emitting diode (LED) light source in a noncontact dermoscope prototype for skin cancer screening. The spectrum and color temperature of the output light can easily and significantly be changed depending on spectral absorption characteristics of the tissues being imaged. The new system has several advantages compared to state-of-the-art phosphor converted ultrabright white LEDs, used in a wide range of medical imaging devices, which have a fixed spectrum and color temperature at a given operating point. In particular, the system can more easily be adapted to the requirements originating from different tissues in the human body, which have wavelength-dependent absorption and reflectivity. This leads to improved contrast for different kinds of imaged tissue components. The concept of such a lighting architecture can be vastly utilized in many other medical imaging devices including endoscopic systems.

No abstract