No abstract

This paper reports the results of a study conducted to examine the impacts of adding graphene oxide (GO) to GBFS-fly ash-based geopolymer concrete. The geopolymer concrete’s compressive strength, thermal conductivity, and modulus of elasticity were assessed. X-ray diffraction (XRD) analysis was conducted to understand the differences in mineralogical composition and a rapid chloride penetration test (RCPT) to investigate the changes in the permeability of chloride ions imposed by GO addition. The results showed that adding 0.25 wt.% GO increases the modulus of elasticity and compressive strength of GBFS-FA concrete by 30.5% and 37.5%, respectively. In contrast, permeability to chloride ions was reduced by 35.3% relative to the GO-free counterparts. Thermal conductivity was decreased as GO dosage increased, with a maximum reduction of 33% being observed in FA65-G35 wt.% samples. Additionally, XRD showed the suitability of graphene oxide in geopolymer concrete. The present research demonstrates very promising features of GO-modified concrete that exhibit improved strength development and durability compared to traditional concrete, thus further advocating for the wider utilization of geopolymer concrete manufactured from industrial byproducts.

No abstract

In the last few years, the building industry experienced a significant development as a response to the demographic growth of human society and to the increasing demand for housing. Their construction involves the traditional use of concrete as a material that provides added strength to the finished building. This is manufactured respecting standard recipes depending on the way of its use. Anyway, all concrete recipes involve the use of mineral aggregates extracted from the riverbed, as is happening in Romania, or rock blocks crushing, as reported in other countries. Under these conditions, the rationalization of the use of natural mineral resources and the identification of new possibilities to reduce their consumption through their replacement with vegetal waste has become an important research issue. In this study, two types of vegetal waste—namely, shredded corn cobs and sunflower stalks—were used to manufacture novel ecological concretes. The vegetal wastes, both in untreated and treated forms (with 20% and 40% of sodium silicate solution), were used to replace 50% of the river (mineral) aggregate volume. The obtained concretes were tested, and the values of some important parameters in the concrete characterization (such as bulk density, water adsorption capacity, compressive strength and splitting tensile strength) were compared with the concrete contains cement CEM II/A-LL 42.5R. The obtained results show that these vegetal wastes have the potential to be used in the manufacturing of new ecological concrete. In addition, this alternative material meets the requirements for the sustainable and healthy development of the environment, offering low-polluting solutions in the context of an increasing demand for constructions.

A main global challenge is finding an alternative material for cement, which is a major source of pollution to the environment because it emits greenhouse gases. Investigators play a significant role in global waste disposal by developing appropriate methods for its effective utilization. Geopolymers are one of the best options for reusing all industrial wastes containing aluminosilicate and the best alternative materials for concrete applications. Waste wood ash (WWA) is used with other waste materials in geopolymer production and is found in pulp and paper, wood-burning industrial facilities, and wood-fired plants. On the other hand, the WWA manufacturing industry necessitates the acquisition of large tracts of land in rural areas, while some industries use incinerators to burn wood waste, which contributes to air pollution, a significant environmental problem. This review paper offers a comprehensive review of the current utilization of WWA with the partial replacement with other mineral materials, such as fly ash, as a base for geopolymer concrete and mortar production. A review of the usage of waste wood ash in the construction sector is offered, and development tendencies are assessed about mechanical, durability, and microstructural characteristics. The impacts of waste wood ash as a pozzolanic base for eco-concreting usages are summarized. According to the findings, incorporating WWA into concrete is useful to sustainable progress and waste reduction as the WWA mostly behaves as a filler in filling action and moderate amounts of WWA offer a fairly higher compressive strength to concrete. A detail study on the source of WWA on concrete mineralogy and properties must be performed to fill the potential research gap.