Objective: To perform cross-cultural adaptation of the Dental Environment Stress (DES), to test its construct validity and reliability, and to identify the sources of stress among Brazilian dental students. Material and Methods: The DES was transculturally adapted to Portuguese using translation/back-translation, review by an expert bilingual committee and consensus building. The first version was tested in a sample of 42 dental students to check the understanding level of the alternatives. The final version was applied to all the students enrolled in a Brazilian Public Dental School. Construct validity was assessed through factor analysis, performed by principal components analysis and Varimax rotation and reliability by internal Cronbach's alpha coefficient (95% CI). Wilcoxon rank sum was conducted to test for gender and Kruskall-Wallis for year comparison. Multivariate analysis relied on ordinal logistic regression modeling. Results: Factor analysis revealed five factors that possessed eigenvalues greater than 1.5 and together explained 46.88% of the total variance. Internal consistency of each factor was adequate, with Cronbach's alpha ranging from 0.65 to 0.84. 'Examinations and grades' (82.80%) was the highest scored item. Females presented higher rates, as well as second's and fifth's years students. The entering students were generally concerned with factors related to "Academic Performance", whereas clinical year students with "Insecurity Concerning their Professional Future". Conclusion: The Portuguese version of the DES presented good results, thus it could be a valid instrument to assess the factors of perceived stress in Lusophone countries, subsidizing the development of strategies to minimize the stress and optimize school performance.
This research aims to probe the porosity profile and polymerization shrinkage of two different dual cure resin cements with different dentin bonding systems. The self-adhesive resin cement RelyX U200 (named RU) and the conventional Allcem Core (named AC) were analyzed by x-ray microtomography (lCT) and Scanning Electron Microscopy (SEM). Each cement was divided into two groups (n 5 5): dual-cured (RUD and ACD) and self-cured (RUC and ACC). lCT demonstrated that the method of polymerization does not influence the porosity profile but the polymerization shrinkage. Fewer concentration of pores was observed for the conventional resin cement (AC), independently the method used for curing the sample. In addition, SEM showed that AC has more uniform surface and smaller particle size. The method of polymerization influenced the polymerization shrinkage, since no contraction for both RUC and ACC was observed, in contrast with results from dual-cured samples. For RUD and ACD the polymerization shrinkage was greater in the lower third of the sample and minor in the upper third. This mechanical behavior is attributed to the polymerization toward the light. mCT showed to be a reliable technique to probe porosity and contraction due to polymerization of dental cements.
K E Y W O R D Sdental composite, photo-cure, polymerization contraction, self-cure, X-ray microtomography
The aim of this study was to evaluate and compare the clinical and radiographic success rates of pulpotomies in primary molars using a new stain-free tricalcium silicate cement (Bio-C Pulpo) versus a conventional white MTA (MTA Angelus) as a pulpotomy medicament for primary teeth. Seventy primary teeth in 33 patients were randomly divided into two groups, MTA Angelus (n = 34) and Bio-C Pulpo (n = 36). Clinical and radiographic follow-up examinations were conducted at seven days (except radiographic follow-up), and at one, three, six and 12 months. At 12 months, the clinical success rate of the MTA Angelus group was 100 percent (28 out of 28), and the radiographic success rate was 100 percent (28 out of 28). In comparison, the clinical success rate for the Bio-C Pulpo group was 100 percent (29 out of 29), and the radiographic success rate was 100 percent (29 out of 29). No significant differences were found between the groups at any follow-up evaluation. According to Fisher´s exact test, a significant difference was observed between the pulpotomy agent and tooth discoloration (p < 0.001). The success rates were 100% for the Bio-C Pulpo group, with no case of discoloration, and 10.31% for the MTA Angelus group. Both MTA Angelus and Bio-C Pulp pulpotomy medicaments are appropriate options for pulpotomies in primary teeth, and enable high clinical and radiographic success rates. However, more long-term studies are required to test the new Bio-C Pulpo medicament.
ObjectivesThis study evaluated smear layer removal by different chemical solutions used with or without ultrasonic activation after post preparation.Materials and MethodsForty-five extracted uniradicular human mandibular premolars with single canals were treated endodontically. The cervical and middle thirds of the fillings were then removed, and the specimens were divided into 9 groups: G1, saline solution (NaCl); G2, 2.5% sodium hypochlorite (NaOCl); G3, 2% chlorhexidine (CHX); G4, 11.5% polyacrylic acid (PAA); G5, 17% ethylenediaminetetraacetic acid (EDTA). For the groups 6, 7, 8, and 9, the same solutions used in the groups 2, 3, 4, and 5 were used, respectively, but activated with ultrasonic activation. Afterwards, the roots were analyzed by a score considering the images obtained from a scanning electron microscope.ResultsEDTA achieved the best performance compared with the other solutions evaluated regardless of the irrigation method (p < 0.05).ConclusionsUltrasonic activation did not significantly influence smear layer removal.
Because of multisystemic impairment in patients with Ellis-van Creveld syndrome, multidisciplinary care may be demanded since birth to assure breastfeeding. This report presents a case of an Ellis-van Creveld infant that was facing breastfeeding difficulties because of maxillary neonatal teeth. A 3 months old male infant with Ellis-van Creveld syndrome was referred to Pediatric Dentistry Department because of two upper neonatal teeth causing breastfeeding difficulties. Clinical examination revealed that teeth position was compatible to 51 and 61, and both presented uncommon ectopic soft tissue placement, conical crown and hypoplastic enamel covered by a large amount of dental biofilm. Radiography indicated they were of normal series and had 2/3 of crown completion. Due to teeth mobility that impaired breastfeeding, treatment option was exodontia. Early tooth eruption, such as in natal and neonatal teeth, by itself can’t be considered a reason for exodontia. But exodontia must be considered when an early erupted tooth(s) impairs breastfeeding, especially in systemically compromised infants. In this present case report, after teeth extraction, the infant was able to breastfeed and gain weight properly.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.