No abstract

No abstract

It was verified that SAE 4130 steel plates crack when laser beam welded at room temperature (RT). To overcome this problem, this work proposes a high temperature (HT) laser welding in order to reduce the residual stresses and create a bainitic structure instead of a martensitic one. A conventional post-welding heat treatment (PWHT) had been used as a comparison for HT. The centerline crack disappeared after a heat treatment of both in-situ (HT) or after inserting in a furnace (PWHT) at 500 °C for 10 minutes. The finite element analyses indicated a residual stress reduction from 163.70 to 3.72 MPa in the fusion zone (FZ) of the welds from RT to HT. The hardness obtained in FZ depends on the thermal cycle induced microstructure of the welds as 400 HV, 340 HV and 250 HV, for martensite (RT), tempered martensite (PWHT) and bainite (HT) micro-constituents. The proposed in-situ high-temperature laser beam welding method proved its usefulness to solve the center crack issue in SAE 4130 joints.

Fernandes de Lima. This open access article is distributed under a Creative Commons Attribution (CC-BY) 3.0 license.