No abstract

Toxic α-dicarbonyl compounds, glyoxal, 2-methylglyoxal, and diacetyl, released from the headspace from butter, margarine, safflower oil, beef fat, and cheese heated at 100 and 200 °C were analyzed by gas chromatography as quinoxaline derivatives. Total amounts of α-dicarbonyl compounds ranged from 40.5 ng/g (butter) to 331.2 ng/g (beef fat) at 100 °C and from 302.4 ng/g (safflower oil) to 4521.5 ng/g (margarine) at 200 °C. The total amount of α-dicarbonyl compounds increased approximately 55- and 15-fold in the headspace of heated butter and margarine, respectively, when the temperature was increased from 100 to 200 °C. However, only slight differences associated with temperature variation were observed in the cases of safflower oil and beef fat (1.3- and 1.1-fold, respectively). Diacetyl was found in the highest amounts among all samples, ranging from 13.9 ± 0.3 ng/g (butter) to 2835.7 ng/g (cheese) at 100 °C and from 112.5 ± 102 ng/g (safflower oil) to 2274.5 ± 442.6 ng/g (margarine) at 200 °C, followed by methylglyoxal, ranging from 13.0 ± 0.5 to 112.7 ± 10.1 ng/g (cheese) at 100 °C and from 34.7 ± 5.0 ng/g (safflower oil) to 1790 ± 372.3 ng/g (margarine) at 200 °C. Much less glyoxal formed, in amounts ranging from 13.6 ± 0.7 ng/g (butter) to 53.4 ± 11.2 ng/g (beef fat) at both temperatures. The amounts of α-dicarbonyl compounds released into the vapor phase from lipid commodities during heating were satisfactorily analyzed.

The application of nanotechnology in pesticide loading can improve the uptake and transportation behavior in plants, which helps to increase the utilization efficiency of pesticides. In this work, prochloraz-loading mesoporous silica nanoparticles were prepared to study the translocation, distribution and degradation of the target pesticide in cucumber plants. Fluorescein isothiocyanate labeled nanoparticles were used to track the distribution of the carriers in plants. Four hours after the treatment on the leaves, the nanoparticles could be found in the leaves, stem, petioles and roots. Fourteen days later the concentration levels of prochloraz and its metabolite were measured in different parts of cucumber using high performance liquid chromatography tandem mass spectrometry. Compared to the conventional suspension concentrate, prochloraz-loaded mesoporous silica nanoparticles had almost the same fungicidal activity, and they tend to be absorbed by cucumber plants with a better deposition performance. The final residue levels of prochloraz in cucumbers were lower than the maximum residue levels, which indicated the low risk of p-MSN application on the plant.

AbstractThe pesticide residues in foods have received increasing attention as one of the most important food safety issues. Therefore, more strict regulations on the maximum residue limits (MRLs) for pesticides in foods have been established in many countries and health organizations, based on the sensitive and reliable analysis methods of pesticide residues. However, the analysis of pesticide residues is a continuing challenge mainly because of the small quantities of analytes as well as the large amounts of interfering substances which can be co-extracted with them, often leading to experimental errors and damage to the analytical instruments. Thus, extensive sample preparation is often required for the pesticide residue analysis for the effective extraction of the analytes and removal of the interferences. This paper focuses on reviewing the recent development in the sample preparation methods for the pesticide residue analysis in foods since 2006. The methods include: liquid-liquid extraction (LLE), supercritical-fluid extraction (SFE), pressurized-liquid extraction (PLE), microwave-assisted extraction (MAE), ultrasound-assisted extraction (UAE), gel permeation chromatography (GPC), solid-phase extraction (SPE), molecularly imprinted polymers (MIPs), matrix solid-phase dispersion (MSPD), solid-phase micro-extraction (SPME), QuEChERS, cloud point extraction (CPE) and liquid phase micro-extraction (LPME), etc. Particularly their advantages, disadvantages and future perspectives will be discussed.

Increasing the crop quality through enhancement of plant health is a challenging task. In this study, nanoselenium (nano-Se) was sprayed on pepper leaves, and the pepper components were compared to those of selenite. It was found that nano-Se (20 mg/L) resulted in a greater performance of plant health. It increased the chlorophyll and soluble sugar levels, which could activate phenylpropane and branched-chain fatty acid pathways, as well as AT3-related enzymes and gene expressions. These led to an enhancement for the synthesis of capsaicinoids, flavonoids, and total phenols. The nano-Se treatment also significantly promoted the expression of phyto-hormones synthesis genes, and consequently increased jasmonic, abscisic, and salicylic acid levels. Proline pathway-related compounds were increased, which could decrease the malondialdehyde and hydroxyl radical levels in crops. This study shows that nano-Se activated capsaicinoid pathways by enhancing photosynthesis and raising soluble sugar levels. The capsaicinoid contents in peppers were then increased, which consequently promoted the accumulation of secondary metabolites and antioxidants.