A study was carried out to determine the feasibility of using the Cu electroplating process to achieve good gap fill in interchip-via ͑ICV͒ wafers, focusing on the effect different current wave forms have on electroplated Cu film properties, the gap fill capability and the chemical mechanical planarization process. It was found that the roughness of direct current ͑dc͒-plated Cu films is at least three times lower than that of pulse-plated films and the roughness of the latter was observed to be strongly dependent on the magnitude of forward (I f ) and reverse (I r ) currents. This produced a significant difference in reflectivity between the two types of films. The as-deposited dc-and pulse-plated Cu films were also found to have specific resistivities of ϳ2.2 and ϳ2.1 ⍀ cm, respectively. They were reduced to a similar value of 1.77 ⍀ cm after annealing at 200°C. All the dc and higher I f pulse-plating processes produced Cu films having an average polish rate of 7000 Å/min with the polish rate U% less than 3%, showing a fluctuating profile across the wafer. The higher I r pulse-plated film showed a very low polish rate of 210 Å/min with the polish rate U% at 58%, resulting in a dome profile. The multistep dc plating process was found unsuitable for the filling of large vias in the ICV wafers as it resulted in conformal plating with a large center seam being seen due to the pinch-off effect at the top of the via. The pulse-plating process showed a significant improvement in the gap fill capability with a reduction in the size of the center void. The pinch-off effect was also greatly reduced when higher I r was used and an increase in bottom coverage could also be seen, resulting in acceptable gap fill with only a small center void in the ICV wafers.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.