Some of the textural changes that occur early in cheese maturation may be related to the redistribution of water within the cheese matrix. To examine this, a model cheese curd system was devised and explored. Initially, cheese curd was prepared using starter and chymosin and the curd pH was controlled by varying the draining and salting pH values. The quantity of serum that could be centrifuged from the resultant curd was less for lower pH curd and decreased in volume with time. The curd pH decreased with time. In the protocol finally adopted, milk was acidified with lactic acid and coagulated with Rennilase 46L. After cheddaring, salting and light pressing, the samples of this curd were finely diced and mixed with glucono-δ-lactone to give curd samples with comparable moisture contents, similar casein proteolysis rates but different pH values. The quantity of serum that could be centrifuged from these samples was greater for pH 5·6 curd than for pH 5·2 curd and decreased faster for the lower pH curd. Neither the curd moisture nor the pH changed significantly during curd storage and the casein proteolysis was low. These results for the model curd system are consistent with known water absorption characteristics of casein curd under ‘equilibrium’ conditions and the effects of pH and mineral salts on this absorption. It was concluded that, during the early stages of cheese ripening, there may be a redistribution of moisture within the cheese, related to the basic properties of the protein matrix and the transient effects of curd salting, rather than as a direct consequence of glycolytic and proteolytic changes.

Changes in rheological properties of cheese curd during the initial stages of ripening, with pH (5.45–6.05) and with time (2–14 days), were evaluated using a small strain oscillatory test and a newly designed large strain deformation test. The new test method developed for evaluation of grated cheese employed extrusion flow technique and was carried out using the Instron Universal Testing Machine. The values for the storage modulus (G') measured using the small strain test increased with an increase in the pH of cheese curds from 5.45 to 5.90. The results from the large strain test showed essentially similar trends. The samples of curd also showed an increased solid‐like behaviour as the pH increased and appeared to become more elastic with time during the two‐week period of analysis.

Oil-in-water emulsions (4 wt % soy oil) containing 4 wt % whey protein hydrolysate (WPH) (27% degree of hydrolysis) and different levels of calcium, magnesium, or potassium chloride were prepared in a two-stage homogenizer. Other emulsions containing 4 wt % WPH but including 0.35 wt % hydroxylated lecithin and different levels of the above minerals were similarly prepared. The formation and stability of these emulsions were determined by measuring oil droplet size distributions using laser light scattering and by confocal scanning laser microscopy and a gravity creaming test. Both lecithin-free and lecithin-containing emulsions showed no change in droplet size distributions with increasing concentration of potassium in the range 0-37.5 mM. In contrast, the diameter of emulsion droplets increased with increasing calcium or magnesium concentration >12.5 mM. Emulsions containing hydroxylated lecithin were more sensitive to the addition of calcium or magnesium than the lecithin-free emulsions. Storage of emulsions at 20 degrees C for 24 h further increased the diameter of droplets and resulted in extensive creaming in emulsions containing >25 mM calcium or magnesium. It appears that both flocculation and coalescence processes were involved in the destabilization of emulsions induced by the addition of divalent cations.

No abstract