No abstract

No abstract

No abstract

A high-temperature, sensible heat thermal energy storage (TES) system is designed for use in a central receiver concentrating solar power plant. Air is used as the heat transfer fluid and solid bricks made out of a high storage density material are used for storage. Experiments were performed using a laboratory-scale TES prototype system, and the results are presented. The air inlet temperature was varied between 300 °C to 600 °C, and the flow rate was varied from 50 cubic feet per minute (CFM) to 90 CFM. It was found that the charging time decreases with increase in mass flow rate. A 1D packed-bed model was used to simulate the thermal performance of the system and was validated with the experimental results. Unsteady 1D energy conservation equations were formulated for combined convection and conduction heat transfer and solved numerically for charging/discharging cycles. Appropriate heat transfer and pressure drop correlations from prior literature were identified. A parametric study was done by varying the bed dimensions, fluid flow rate, particle diameter, and porosity to evaluate the charging/discharging characteristics, overall thermal efficiency, and capacity ratio of the system.

Thermal energy storage for concentrating solar thermal power (CSP) plants can help in overcoming the intermittency of the solar resource and also reduce the levelized cost of energy (LCOE) by utilizing the power block for extended periods of time. In general, heat can be stored in the form of sensible heat, latent heat, and thermochemical reactions. This article describes the development of a costeffective latent heat storage TES at the University of South Florida (USF). Latent heat storage systems have higher energy density compared to sensible heat storage systems. However, most phase change materials (PCMs) have low thermal conductivity that leads to slow charging and discharging rates. The effective thermal conductivity of PCMs can be improved by forming small macrocapsules of PCM and enhancing convective heat transfer by submerging them in a liquid. A novel encapsulation procedure for high-temperature PCMs that can be used for thermal energy storage (TES) systems in CSP plants is being developed at USF. When incorporated in a TES system, these PCMs can reduce the system costs to much lower rates than currently used systems. Economical encapsulation is achieved by using a novel electroless deposition technique. Preliminary results are presented and the factors that are being considered for process optimization are discussed.