[1] Explosive volcanic eruptions are defined as the violent ejection of gas and hot fragments from a vent in the Earth's crust. Knowledge of ejection velocity is crucial for understanding and modeling relevant physical processes of an eruption, and yet direct measurements are still a difficult task with largely variable results. Here we apply pioneering high-speed imaging to measure the ejection velocity of pyroclasts from Strombolian explosive eruptions with an unparalleled temporal resolution. Measured supersonic velocities, up to 405 m/s, are twice higher than previously reported for such eruptions. Individual Strombolian explosions include multiple, sub-second-lasting ejection pulses characterized by an exponential decay of velocity. When fitted with an empirical model from shock-tube experiments literature, this decay allows constraining the length of the pressurized gas pockets responsible for the ejection pulses. These results directly impact eruption modeling and related hazard assessment, as well as the interpretation of geophysical signals from monitoring networks. Citation: Taddeucci, J

Explosive volcanic eruptions are commonly associated with intense electrical activity and lightning. Direct measurement of the electric potential at the vent, where the electric activity in the volcanic plume is fi rst observed, is severely impeded, limiting progress in its investigation. We have achieved volcanic lightning in the laboratory during rapid decompression experiments of gas-particle mixtures under controlled conditions, and recorded it using a high-speed camera and two antennas. We fi nd that lightning is controlled by the dynamics of the particle-laden jet and by the abundance of fi ne particles. The relative movement of clusters of charged particles generates the electrical potential, which is necessary for lightning. The experimental generation of volcanic lightning suggests that rapid progress can now be expected in understanding electrical phenomena in volcanic plumes to implement lightning monitoring systems and the forecasting of volcanic ash emissions.

[1] Magmas in volcanic conduits commonly contain microlites in association with preexisting phenocrysts, as often indicated by volcanic rock textures. In this study, we present two different experiments that investigate the flow behavior of these bidisperse systems. In the first experiments, rotational rheometric methods are used to determine the rheology of monodisperse and polydisperse suspensions consisting of smaller, prolate particles (microlites) and larger, equant particles (phenocrysts) in a bubble-free Newtonian liquid (silicate melt). Our data show that increasing the relative proportion of prolate microlites to equant phenocrysts in a magma at constant total particle content can increase the relative viscosity by up to three orders of magnitude. Consequently, the rheological effect of particles in magmas cannot be modeled by assuming a monodisperse population of particles. We propose a new model that uses interpolated parameters based on the relative proportions of small and large particles and produces a considerably improved fit to the data than earlier models. In a second series of experiments we investigate the textures produced by shearing bimodal suspensions in gradually solidifying epoxy resin in a concentric cylinder setup. The resulting textures show the prolate particles are aligned with the flow lines and spherical particles are found in well-organized strings, with sphere-depleted shear bands in high-shear regions. These observations may explain the measured variation in the shear thinning and yield stress behavior with increasing solid fraction and particle aspect ratio. The implications for magma flow are discussed, and rheological results and textural observations are compared with observations on natural samples.

Volcanic lightning studies have revealed that there is a relatively long‐lasting source of very high frequency radiation associated with the onset of explosive volcanic eruptions that is distinct from radiation produced by lightning. This very high frequency signal is referred to as “continual radio frequency (CRF)” due to its long‐lasting nature. The discharge mechanism producing this signal was previously hypothesized to be caused by numerous, small (10–100 m) leader‐forming discharges near the vent of the volcano. To test this hypothesis, a multiparametric data set of electrical and volcanic activity occurring during explosive eruptions of Sakurajima Volcano in Japan was collected from May to June 2015. Our observations show that a single CRF impulse has a duration on the order of 160 ns (giving an upper limit on discharge length of 10 m) and is distinct from near‐vent lightning discharges that were on the order of 30 m in length. CRF impulses did not produce discernible electric field changes and occurred in the absence of a net static electric field. Lightning mapping data and infrared video observations of the eruption column showed that CRF impulses originated from the gas thrust region of the column. These observations indicate that CRF impulses are not produced by small, leader‐forming discharges but rather are more similar to a streamer discharge, likely on the order of a few meters in length.

The recent Eyjafjallajökull (Iceland) eruption strikingly underlined the vulnerability of a globalized society to the atmospheric dispersal of volcanic clouds from even moderate-size eruptions. Ash aggregation controls volcanic clouds dispersal by prematurely removing fi ne particles from the cloud and depositing them more proximally. Physical parameters of ash aggregates have been modeled and derived from ash fallout deposits of past eruptions, yet aggregate sedimentation has eluded direct measurement, limiting our ability to predict the dispersal of volcanic clouds. Here we use fi eld-based, highspeed video analysis together with laboratory experiments to provide the fi rst in situ investigation and parameterization of the physical features and settling dynamics of ash aggregates from a volcanic cloud. In May 2010, high-speed video footage was obtained of both ash particles and aggregates settling from the Eyjafjallajökull volcano eruption cloud at a distance of 7 km from the vent; fallout samples were collected simultaneously. Experimental laboratory determinations of the density, morphology, and settling velocity of individual ash particles enable their distinction from aggregates. The combination of fi eld and experimental analyses allows a full characterization of the size, settling velocity, drag coeffi cient, and density distributions of ash aggregates as well as the size distribution of their component particles. We conclude that ash aggregation resulted in a tenfold increase in mass sedimentation rate from the cloud, aggravating the ash hazard locally and modifying cloud dispersal regionally. This study provides a valuable tool for monitoring explosive eruptions, capable of providing robust input parameters for models of cloud dispersal and consequent hazard forecast.

No abstract

The ingestion of volcanic ash by jet engines is widely recognized as a potentially fatal hazard for aircraft operation. The high temperatures (1,200–2,000 °C) typical of jet engines exacerbate the impact of ash by provoking its melting and sticking to turbine parts. Estimation of this potential hazard is complicated by the fact that chemical composition, which affects the temperature at which volcanic ash becomes liquid, can vary widely amongst volcanoes. Here, based on experiments, we parameterize ash behaviour and develop a model to predict melting and sticking conditions for its global compositional range. The results of our experiments confirm that the common use of sand or dust proxy is wholly inadequate for the prediction of the behaviour of volcanic ash, leading to overestimates of sticking temperature and thus severe underestimates of the thermal hazard. Our model can be used to assess the deposition probability of volcanic ash in jet engines.

No abstract