Electrochemical sensors have been developed by modifying a glassy carbon electrode with organo‐kaolinite hybrid materials. These materials were obtained by the grafting of four ionic liquids (1‐(2‐hydroxyethyl)‐4‐benzylpyridinium chloride, 1‐(2‐hydroxyethyl)‐4‐(tert‐butyl)pyridinium chloride, 1‐(2‐hydroxyethyl)‐4‐ethylpyridinium chloride and 1‐(2‐hydroxyethyl)‐4‐methylpyridinium chloride) on the interlayer aluminol surfaces of kaolinite. With the presence of ionic liquids in the interlayer space of kaolinite, the hybrid materials acquired anion exchange properties and were successfully applied as electrode modifier for the electroanalysis of thiocyanate (SCN−), an anion of medical and environmental concern. A pre‐concentration/detection strategy was used to overcome the interfering effect of the electrolytic solution. After the optimisation of some key experimental parameters (sodium nitrate as electrolyte, 5 min of accumulation time) calibration curves were plotted. Excellent linearity was obtained in the low concentration region (1×10−6 M to 4×10−5 M). The lowest detection limit (15 nM) was obtained with the benzylpyridinium functionalized kaolinite and the highest (60 nM) with the methylpyridinium functionalized kaolinite. Interfering anions (NO3−, Cl−, SO42− and CH3COO−) present in the pre‐concentration solution were found to interfere with SCN− but the sensors remained stable and produced reproducible signals. The most sensitive sensor was successfully applied for the amperometric determination of SCN− in human saliva samples.
A gold electrode modified by a thin film of cationic kaolinite was used for the electrochemical detection of iodide in aqueous solution in the presence of thiosulfate. At gold electrode, iodide showed two electrochemical systems in the potential range explored (0.10 V to 0.85 V). The pH‐independent system was assigned to the redox couple I2/I− and the pH‐dependent one assigned to the redox couple HIO/
. For increased amount of thiosulfate the oxidation peak intensity of the first system increases sharply followed by the gradual decrease of the reduction peak, due to the chemical reaction between thiosulfate and oxidized iodide. The calibration curve in the presence of excess thiosulfate resulted in an increase of the sensitivity by a factor of 7. To improve this sensitivity, the bare gold electrode was coated by a thin film of an anionic exchanger kaolinite, obtained by grafting the ionic liquid (1‐(2‐hydroxyethyl)‐4‐(tert‐butyl) pyridinium chloride). Accumulation‐detection method yielded a spectacular increase of the oxidation peak current of iodide in the presence of thiosulfate ions. At optimized experimental conditions, a sensitivity of 2.45 μA.μM−1 and a detection limit of 65 nM were obtained. The method was successfully applied for total iodine determination in povidone−iodine formulation.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.