Electron-beam-induced damages in methylammonium lead triiodide (MAPbI3) perovskite thin films were studied by cathodoluminescence (CL) spectroscopy. We find that high-energy electron beams can significantly alter perovskite properties through two distinct mechanisms: (1) defect formation caused by irradiation damage and (2) phase transformation induced by electron-beam heating. The former mechanism causes quenching and broadening of the excitonic peaks in CL spectra, whereas the latter results in new peaks with higher emission photon energy. The electron-beam damage strongly depends on the electron-beam irradiation conditions. Although CL is a powerful technique for investigating the electronic properties of perovskite materials, irradiation conditions should be carefully controlled to avoid any significant beam damage. In general, reducing acceleration voltage and probing current, coupled with low-temperature cooling, is more favorable for CL characterization and potentially for other scanning electron-beam-based techniques as well. We have also shown that the stability of perovskite materials under electron-beam irradiation can be improved by reducing defects in the original thin films. In addition, we investigated effects of electron-beam irradiation on formamidinium lead triiodide (FAPbI3) and CsPbI3 thin films. FAPbI3 shows similar behavior as MAPbI3, whereas CsPbI3 displays higher resistance to electron-beam damage than its organic–inorganic hybrid counterparts. Using CsPbI3 as a model material, we observed nonuniform luminescence in different grains of perovskite thin films. We also discovered that black-to-yellow phase transformation of CsPbI3 tends to start from the junctions at grain boundaries.
MS Purpose:To investigate the value of viscosity measured with ultrasonographic (US) elastography in liver fibrosis staging and to determine whether the use of a viscoelastic model to estimate liver elasticity can improve its accuracy in fibrosis staging. Materials and Methods:The study, which was performed from February 2010 to March 2011, was compliant with HIPAA and approved by the institutional review board. Written informed consent was obtained from each subject. Ten healthy volunteers (eight women and two men aged 27-55 years) and 35 patients with liver disease (17 women and 18 men aged 19-74 years) were studied by using US elasticity measurements of the liver (within 6 months of liver biopsy). US data were analyzed with the shear wave dispersion ultrasound vibrometry (SDUV) method, in which elasticity and viscosity are measured by evaluating dispersion of shear wave propagation speed, as well as with the time-to-peak (TTP) method, where tissue viscosity was neglected and only elasticity was estimated from the effective shear wave speed. The hepatic fibrosis stage was assessed histologically by using the METAVIR scoring system. The correlation of elasticity and viscosity was assessed with the Pearson correlation coefficient. The performances of SDUV and TTP were evaluated with receiver operating characteristic (ROC) curve analysis. Results:The Conclusion:The results suggest that elasticity and viscosity measured between 95 Hz and 380 Hz by using SDUV are correlated and that elasticity measurements from SDUV and TTP showed substantially similar performance in liver fibrosis staging, although elasticity calculated from SDUV provided a better area under the ROC curve.q RSNA, 2012 Supplemental material: http://radiology.rsna.org/lookup /suppl
The state of application of atom probe tomography to electronic materials is assessed. The benefits and challenges of the technique are discussed with regard to its impact on this field of materials science. Specimen preparation in particular is emphasized as the key to success with modern atom probes. Electronic materials referenced in this paper include components of complementary metal/oxide/semiconductor (CMOS) structures, compound semiconductors, and thin films for data storage and general applications. Many examples from recent work are provided as illustrations of the types of information that can be derived and the impact this information can have on the research, development, processing, and failure analysis of electronic materials.
Hydrothermal synthesis is challenging in metal oxide systems with diverse polymorphism, as reaction products are often sensitive to subtle variations in synthesis parameters. This sensitivity is rooted in the non-equilibrium nature of low-temperature crystallization, where competition between different metastable phases can lead to complex multistage crystallization pathways. Here, we propose an ab initio framework to predict how particle size and solution composition influence polymorph stability during nucleation and growth. We validate this framework using in situ X-ray scattering, by monitoring how the hydrothermal synthesis of MnO2 proceeds through different crystallization pathways under varying solution potassium ion concentrations ([K+] = 0, 0.2, and 0.33 M). We find that our computed size-dependent phase diagrams qualitatively capture which metastable polymorphs appear, the order of their appearance, and their relative lifetimes. Our combined computational and experimental approach offers a rational and systematic paradigm for the aqueous synthesis of target metal oxides.
Inorganic nitrides with wurtzite crystal structures are well-known semiconductors used in optoelectronic devices. In contrast, rocksalt-based nitrides are known for their metallic and refractory properties. Breaking this dichotomy, here we report on ternary nitride semiconductors with rocksalt crystal structures, remarkable optoelectronic properties, and the general chemical formula MgxTM1-xN (TM=Ti, Zr, Hf, Nb). These compounds form over a broad metal composition range and our experiments show that Mg-rich compositions are nondegenerate semiconductors with visible-range optical absorption onsets (1.8-2.1 eV). Lattice parameters are compatible with growth on a variety of substrates, and epitaxially grown MgZrN2 exhibits remarkable electron mobilities approaching 100 cm 2 V -1 s -1 . Ab initio calculations reveal that these compounds have disorder-tunable optical properties, large dielectric constants and low carrier effective masses that are insensitive to disorder. Overall, these experimental and theoretical results highlight MgG-3TMNG-2 rocksalts as a new class of semiconductor materials with promising properties for optoelectronic applications.
Methods of preoperative radiologic localization of insulinoma were compared in 52 patients, 44 of whom had solitary tumors. Examinations performed in these 44 patients were preoperative ultrasonography (US) in 28, angiography in 26, and computed tomography in 23. Prospective sensitivities were 61%, 54%, and 30%, respectively. Imaging sensitivities were lower for the eight patients with multiple insulinomas. In 28 of the 44 patients, intraoperative US was performed without the examiner being aware of the surgical findings. The sensitivity was 84%. Four insulinomas were not palpable but were visualized sonographically. The combined sensitivity of intraoperative US and surgical palpation for detecting solitary insulinomas was 100%. High-frequency intraoperative US is valuable for detecting occult solitary insulinomas and considerably useful for determining the proximity of insulinomas to the pancreatic and bile ducts.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.