No abstract

Strengthening reinforced concrete (RC) beams with openings by using aramid fiber reinforcement polymers (AFRP) on the beams' surfaces offers a useful solution for upgrading concrete structures to carry heavy loads. This paper presents a repairing technique of the AFRP sheets that effectively strengthens RC beams, controls both the failure modes and the stress distribution around the beam chords and enhances the serviceability (deflection produced under working loads be sufficiently small and cracking be controlled) of pre-cracked RC beams with openings. To investigate the possible damage that was caused by the service load and to simulate the structure behavior in the site, a comprehensive experimental study was performed. Two unstrengthened control beams, four beams that were pre-cracked before the application of the AFRP sheets and one beam that was strengthened without pre-cracking were tested. Cracking was first induced, followed by repair using various orientations of AFRP sheets, and then the beams were tested to failure. This load was kept constant during the strengthening process. The results show that both the preexisting damage level and the FRP orientation have a significant effect on strengthening effectiveness and failure mode. All of the strengthened specimens exhibited higher capacities with capacity enhancements ranging from 21.8 to 66.4%, and the crack width reduced by 25.6-82.7% at failure load compared to the control beam. Finally, the authors present a comparison between the experimental results and the predictions using the ACI 440.2R-08 guidelines.

No abstract

No abstract

No abstract

The use of externally bonded fiber reinforced polymer (FRP) sheets, strips or steel plates is a modern and convenient way for strengthening of reinforced concrete (RC) beams. Several researches have been carried out on reinforced concrete beams with web openings that strengthened using fiber reinforced polymer composite. Majority of researches focused on shear strengthening compared with flexural strengthening, while others studied the effect of openings on shear and flexural separately with various loading. This paper investigates the impact of more than sixty articles on opening reinforced concrete beams with and without strengthening by fiber reinforcement polymers FRP. Moreover, important practical issues, which are contributed in shear strengthening of beams with different strengthening techniques, such as steel plate and FRP laminate, and detailed with various design approaches are discussed. Furthermore, a simple technique of applying fiber reinforced polymer contributed with steel plate for strengthening the RC beams with openings under different load application is concluded. Directions for future research based on the existing gaps of the present works are presented.

Based on axially compressive tests on 6 short columns and 27 slender columns of lightweight aggregate concrete filled steel tube (LACFST)，macroscopic deformation characters，axial force-longitudinal strain curves，failure mode and failure mechanism are studied. The results are also compared with these of the normal concrete filled steel tube. The test results demonstrated that slenderness ratio is the main influence factor to the behavior of LACFST long columns under axial load. The greater the slenderness ratio is, the lower the ultimate bearing capacity and stability coefficient of the specimen are, and the performances of core concrete affect the stability behavior of lightweight aggregate concrete and normal concrete filled steel tube long columns. The stability coefficient of specimens is determined by the peak strain of concrete and unrelated to the peak strength of concrete. The stability coefficient increases when the peak strain of concrete increasing. Comparison results show that calculation formula in Europe code EC4 (1996) can be applied to calculate the bearing capacity of LACFST columns under axially compressive load.

No abstract