The incorporation of tetraoxolene radical bridging ligands into a microporous magnetic solid is demonstrated. Metalation of the redox-active bridging ligand 2,5-dichloro-3,6-dihydroxy-1,4-benzoquinone (LH2) with Fe(II) affords the solid (Me2NH2)2[Fe2L3]·2H2O·6DMF. Analysis of X-ray diffraction, Raman spectra, and Mössbauer spectra confirm the presence of Fe(III) centers with mixed-valence ligands of the form (L3)(8-) that result from a spontaneous electron transfer from Fe(II) to L(2-). Upon removal of DMF and H2O solvent molecules, the compound undergoes a slight structural distortion to give the desolvated phase (Me2NH2)2[Fe2L3], and a fit to N2 adsorption data of this activated compound gives a BET surface area of 885(105) m(2)/g. Dc magnetic susceptibility measurements reveal a spontaneous magnetization below 80 and 26 K for the solvated and the activated solids, respectively, with magnetic hysteresis up to 60 and 20 K. These results highlight the ability of redox-active tetraoxolene ligands to support the formation of a microporous magnet and provide the first example of a structurally characterized extended solid that contains tetraoxolene radical ligands.
The average sequential water molecule binding enthalpies to large water clusters (between 19 and 124 water molecules) containing divalent ions were obtained by measuring the average number of water molecules lost upon absorption of an UV photon (193 or 248 nm) and using a statistical model to account for the energy released into translations, rotations, and vibrations of the products. These values agree well with the trend established by more conventional methods for obtaining sequential binding enthalpies to much smaller hydrated divalent ions. The average binding enthalpies decrease to a value of ~10.4 kcal/mol for n > ~40 and are insensitive to the ion identity at large cluster size. This value is close to that of the bulk heat of vaporization of water (10.6 kcal/mol) and indicates that the structure of water in these clusters may more closely resemble that of bulk liquid water than ice, owing either to a freezing point depression or rapid evaporative cooling and kinetic trapping of the initial liquid droplet. A discrete implementation of the Thomson equation using parameters for liquid water at 0 °C generally fits the trend in these data but provides values that are ~0.5 kcal/mol too low.
Continuous wave (CW) pump-probe surface-enhanced Raman spectroscopy (SERS) is used to examine a range of plasmon-driven chemical behavior in the molecular SERS signal of trans-1,2-bis(4-pyridyl)ethylene (BPE) adsorbed on individual Au nanosphere oligomers (viz., dimers, trimers, tetramers, etc.). Well-defined new transient modes are caused by high fluence CW pumping at 532 nm and are monitored on the seconds time scale using a low intensity CW probe field at 785 nm. Comparison of time-dependent density functional theory (TD-DFT) calculations with the experimental data leads to the conclusion that three independent chemical processes are operative: (1) plasmon-driven electron transfer to form the BPE anion radical; (2) BPE hopping between two adsorption sites; and (3) trans-to- cis-BPE isomerization. Resonance Raman and electron paramagnetic resonance (EPR) spectroscopy measurements provide further substantiation for the observation of an anion radical species formed via a plasmon-driven electron transfer reaction. Applications of these findings will greatly impact the design of novel plasmonic devices with the future ability to harness new and efficient energetic pathways for both chemical transformation and photocatalysis at the nanoscale level.
Photofragment translational spectroscopy was used to study the photodissociation dynamics of the phenyl radical C(6)H(5) at 248 and 193 nm. At 248 nm, the only dissociation products observed were from H atom loss, attributed primarily to H+o-C(6)H(4) (ortho-benzyne). The observed translational energy distribution was consistent with statistical decay on the ground state surface. At 193 nm, dissociation to H+C(6)H(4) and C(4)H(3)+C(2)H(2) was observed. The C(6)H(4) fragment can be either o-C(6)H(4) or l-C(6)H(4) resulting from decyclization of the phenyl ring. The C(4)H(3)+C(2)H(2) products dominate over the two H loss channels. Attempts to reproduce the observed branching ratio by assuming ground state dynamics were unsuccessful. However, these calculations assumed that the C(4)H(3) fragment was n-C(4)H(3), and better agreement would be expected if the lower energy i-C(4)H(3)+C(2)H(2) channel were included.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.