No abstract

No abstract

Flash reduction of graphene oxide is an efficient method for producing high quality reduced graphene oxide under room temperature ambient conditions without the use of hazardous reducing agents (such as hydrazine and hydrogen iodide). The entire process is fast, low‐cost, and suitable for large‐scale fabrication, which makes it an attractive process for industrial manufacturing. Herein, we present a simple fabrication method for a flexible in‐plane graphene micro‐supercapacitor using flash light irradiation. All carbon‐based, monolithic supercapacitors with in‐plane geometry can be fabricated with simple flash irradiation, which occurs in only a few milliseconds. The thinness of the fabricated device makes it highly flexible and thus useful for a variety of applications, including portable and wearable electronics. The rapid flash reduction process creates a porous graphene structure with high surface area and good electrical conductivity, which ultimately results in high specific capacitance (36.90 mF cm−2) and good cyclic stability up to 8,000 cycles.

We investigated the neuropsychological profile of subjects in a subclinical obsessive-compulsive disorder (OCD) sample. Psychometrically defined subclinical obsessive-compulsive (n = 21) and control (n = 22) subjects were examined. Comprehensive neuropsychological tests evaluating verbal/nonverbal memory, attention, and executive function were administered. The subclinical obsessive-compulsive group showed poorer performances on the Wisconsin Card Sorting Test (WCST), F(1, 41) = 13.80, p < .001, and Trail-Making Test (TMT), F(1, 41) = 5.48, p < .05, compared with the control group. The subclinical obsessive-compulsive group showed higher rates of total errors, perseverative errors, and perseverative responses. In addition, the subclinical obsessive-compulsive group committed a greater number of errors in the TMT. However, the groups showed no performance differences in the TMT after controlling for the effects of depression and anxiety, F(1, 39) = 0.11, p = .739. These results suggest that subclinical obsessive-compulsives seemed to display deficits in executive functioning. This neuropsychological profile is consistent with current theories proposing that executive dysfunction may serve as the pathophysiological mechanism underlying the development of obsessive-compulsive disorder.

No abstract

No abstract

No abstract

The aim of this study was to investigate the effect of G-CEM One Primer (GCOP) and self-etching adhesive on the microtensile bond strength (µTBS) between self-adhesive resin cement G-CEM One (GCO) and dentin. Teeth were sectioned to expose the flat dentin surface and randomly assigned into five groups (n = 15) according to the dentin surface treatment: 1) no surface treatment, 2) GCOP, 3) All-Bond Universal (ABU), 4) GCOP followed by ABU (GCOP/ABU), 5) ABU followed by GCOP (ABU/GCOP). The composite resin blocks were bonded to the dentin surface using GCO. The specimens were stored in distilled water at 37 °C for 24 h, then sectioned into sticks (1 mm × 10 mm). The μTBS values were statistically analyzed using 1-way analysis of variance (ANOVA) and Tukey’s honestly significant difference (HSD) test (α = 0.05) and failure mode was examined under a stereomicroscope. The bonding interface of each specimen was evaluated using confocal laser scanning microscopy. The GCOP group exhibited the highest µTBS value and there were no significant differences observed between GCOP, GCOP/ABU, ABU/GCOP groups (p > 0.05). The use of GCOP with GCO results in the improved µTBS between GCO and dentin. In conclusion, using only GCOP with GCO for bonding of indirect restoration is extremely simple and increasing bond strength.