No abstract

Rock bursts are typically accompanied by multiple shocks. In order to explore the dynamic characteristics of filling materials in rock burst roadways, we employ the split Hopkinson pressure bar (SHPB) test to analyze the dynamic mechanical response of mortar and concrete under cyclical impact. The SHPB test results of the large-size specimen indicate the improvement in the waveform shape and the reduction in the wave dispersion via the application of the rubber sheet as the pulse shaper. Under cyclic impact, the peak stress and energy utilization ratio of mortar and concrete specimens were reduced, demonstrating obvious fatigue characteristics. The mortar peak stress and energy utilization ratio were observed to be sensitive to the impact times, while those of concrete were sensitive to impact pressure. The damage evolution of mortar and concrete exhibited very similar trends under the cyclic impact load, whereby the impact pressure had minimal effect on the damage evolution.

The Split Hopkinson Pressure Bar (SHPB) test device is an important tool to study the dynamic characteristics of concrete materials. Inertial effect is one of the main factors that cause inaccurate results in SHPB tests of concrete materials. To solve this problem, Large-diameter SHPB tests on concrete and mortar were performed. A dynamic increase factor (DIF) model considering strain rate effect and inertia effect was established. This model provides a scientific reference for studying the dynamic mechanical properties of concrete materials. The experimental results indicate that the strain rate effect of concrete is more sensitive than that of mortar, but the inertia effect of mortar is more sensitive than that of concrete. Under the same strain rate, the energy utilization rate, average fragment size, and impact potentiality of mortar are higher than concrete.

Rock-like brittle materials under dynamic load will show more complex dynamic mechanical properties than those under static load. The relationship between pulse waveform characteristics and strain rate effect and inertia effect is rarely discussed in the split-Hopkinson pressure bar (SHPB) numerical simulation research. In response to this problem, this paper discusses the effects of different pulse types and pulse waveforms on the incident waveform and dynamic response characteristics of specimens based on particle flow code (PFC). The research identifies a critical interval of rock dynamic strength, where the dynamic strength of the specimen is independent of the strain rate but increases with the amplitude of the incident stress wave. When the critical interval is exceeded, the dynamic strength is determined by the strain rate and strain rate gradient. The strain rate of the specimen is only related to the slope of the incident stress wave and is independent of its amplitude. It is also determined that the inertia effect cannot be eliminated in the SHPB. The slope of the velocity pulse waveform determines the strain rate of the specimen, the slope of the force pulse waveform determines the strain rate gradient of the specimen, and the upper bottom time determines the strain rate of the specimen. It provides a reference for SHPB numerical simulation. A dynamic strength prediction model of rock-like materials is then proposed, which considers the effects of strain rate and strain rate gradient.