We investigate the average power scaling of two diode-pumped Yb-doped fiber amplifiers emitting a diffraction-limited beam. The first fiber under investigation with a core diameter of 30 µm was able to amplify a 10 W narrow linewidth seed laser up to 2.8 kW average output power before the onset of transverse mode instabilities (TMI). A further power scaling was achieved using a second fiber with a smaller core size (23µm), which allowed for a narrow linewidth output power of 3.5 kW limited by stimulated Brillouin scattering (SBS). We mitigated SBS using a spectral broadening mechanism, which allowed us to further increase the output power to 4.3 kW only limited by the available pump power. Up to this power level, a high slope efficiency of 90% with diffraction-limited beam quality and without any sign of TMI or stimulated Raman scattering for a spectral dynamic range of higher than -80 dB was obtained.

In this contribution we investigate the transversal mode instability behavior of a ytterbium-doped commercial 20/400 fiber and obtain 2.9 kW of output power after optimizing the influencing parameters. In this context, we evaluate the influence of the bend diameter and the pump wavelength within the scope of the absorption length and the length of the fiber. Furthermore, with a newly developed fiber we report on 4.4 kW of single-mode output power at 40 cm bend diameter.

We report on a newly designed and fabricated ytterbium-doped large mode area fiber with an extremely low NA (~0.04) and related systematic investigations on fiber parameters that crucially influence the mode instability threshold. The fiber is used to demonstrate a narrow linewidth, continuous wave, single mode fiber laser amplifier emitting a maximum output power of 3 kW at a wavelength of 1070 nm without reaching the mode-instability threshold. A high slope efficiency of 90 %, excellent beam quality, high temporal stability, and an ASE suppression of 70 dB could be reached with a signal linewidth of only 170 pm.

Systematic experimental investigations toward the mode instability (MI) threshold in low-NA fibers are performed. By testing several fibers with varying V-parameters drawn from the same preform, a high degree of reproducibility of the experimental conditions could be achieved. This allows for systematic investigations on isolated parameters influencing the complex behavior of MI. A maximum MI threshold of 2 kW could be demonstrated for the tested fibers, which represents a new record output power for narrow linewidth fiber amplifiers. The MI threshold was found to sensitively depend on the V-parameter for large V-parameters (>2), but to be robust for smaller V-parameters. Furthermore, the fiber bending diameter and the seed excitation conditions were identified to sensitively influence the MI threshold.

We report on detailed in situ distributed temperature measurements inside a high power fiber amplifier. The deducted thermal load and the transversal mode instability (TMI) threshold of a commercial large mode area fiber with 25 μm core and 400 μm cladding were measured at various seed wavelengths. By matching these results with detailed simulations we show that photodarkening has a negligible impact on the thermal load and, therefore, on the TMI threshold in this fiber.