An abdominal computed tomographic scan was modified by inserting 10 simulated colonic polyps with use of methods that closely mimic the attenuation, noise, and polyp-colon wall interface of naturally occurring polyps. A shape-based polyp detector successfully located six of the 10 polyps. When settings that enhanced the edge profile of polyps were chosen, eight of 10 polyps were detected. There were no false-positive detections. Shape analysis is technically feasible and is a promising approach to automated polyp detection.

Dynamic MR imaging of the glenohumeral joint is possible over a wide range of physiologic motion in vertically open systems. Use of an MR tracking coil enabled accurate tracking of the anatomy of interest. These preliminary measurements of normal glenohumeral motion patterns begin to establish normal ranges of motion and constitute a necessary first step in characterizing pathologic motion in patients with common clinical problems such as instability and impingement.

The sensitivity of conventional CT colonography is limited by the percentage of the mucosal surface seen. Map projection CT colonography overcomes this problem and provides a more sensitive method with a high PPV for detecting polyps than other methods currently being investigated.

No abstract

CT scanning at 5 mm collimation and up to pitch 2 is adequate for detection of high contrast lesions as small as 4 mm in this model. However, lesion size and geometry are less accurately depicted than at narrower collimation and lower pitch settings.