BackgroundTwo-dimensional (2D) measurements of acetabular morphology and orientation are well known; there is less information on these acetabular characteristics in three dimensions. One important reason is the lack of standardized reference planes for the pelvis, especially in relation to the spinopelvic unit; another is that no method precisely assesses the acetabulum in three-dimensional (3D) orientation based on its axis rather than on the directions of the edges of the acetabular rim. We present an objective, highly reliable and accurate, axis-based approach to acetabular anthropometry in the measurement of acetabular volume and spatial orientation in both normal and pathologic hips. This was done using reference planes based on the sacral base (SB) and true acetabular axis in 3D computed tomography (CT) pelvic reconstruction.MethodsRadiological examinations of 30 physiologic pelves (60 acetabula) were included in the study. Reliability and accuracy of the method were verified by comparing acetabular angles in 2D pelvic scans with 3D reconstructions. We also applied the method to two pathologic acetabula.ResultsComparison of axis position in the horizontal plane revealed significant positive correlations between 2D angle measurements (acetabular anteversion angle [AAA] and anterior acetabular index [AAI]) and 3D measurement of anteversion angle (p < 0.001 and p = 0.012, respectively). In the frontal plane, there was no difference between abduction angle, measured on topogram, and inclination angle, obtained from a 3D model (p = 0.517). In the sagittal plane, there was a significant negative correlation between AAA and acetabular tilt (p < 0.001). Inter- and intra-observer reproducibility was excellent for determination of the sacral-base plane and assessment of volume, with Fleiss κ coefficients of 0.850 and 0.783, respectively, and intraclass correlation coefficients of 0.900 and 0.950, respectively. Inter-observer reproducibility for evaluation of acetabular axis ranged from 0.783 to 0.883, and intra-rater reliability ranged from 0.850 to 0.900 for all 3D angles.ConclusionsOur method is a new, reliable diagnostic tool for assessing the acetabula in both normal and pathologic hip joints. The sacral-base plane can be used as a stable reference that takes the relationship of the acetabulum to the spinopelvic unit into consideration.Electronic supplementary materialThe online version of this article (doi:10.1186/s12891-015-0503-8) contains supplementary material, which is available to authorized users.

There is no consensus on the definition of dysplasia of the hip (DH). Past and present concepts used to describe DH do not form a complete view of the pathology. Moreover, some authors still present the disease as congenital, not developmental. This prompted authors to analyze the evolution of the definition of DH. Based on the biomedical databases 500 articles and books in the field of hip dysplasia were found and analyzed. Fifteen definitions of hip dysplasia met inclusion criteria, subsequently were analyzed and presented in chronological order. The analysis revealed that currently there is no single, universal definition of hip dysplasia in the aspect of morphological, clinical, and radiological studies. Despite the widely-used term of DH, it is described imprecisely and in different ways. Therefore, it is necessary to develop a multidisciplinary definition of this pathology covering all aspects of hip disorders considered valid in modern orthopaedics.

Background: Although Fassier-Duval (FD) rods have been used for almost 2 decades, knowledge of factors predisposing to their failure is limited. Thus, the purpose of this study was to: (1) present the most common complications of FD rodding, (2) present tips on how to avoid or overcome them, and (3) identify factors predisposing to treatment failure. Methods: Fifty-eight rod segments in 19 patients with osteogenesis imperfecta (mainly type III) underwent analysis with a median follow-up (FU) time of 4.4 years. We assessed the total number of complications clinically and radiographically. Next, the possible predisposing factors leading to failure were assessed using the Mann-Whitney U test. In addition, we evaluated the cutoff age for the increased rate of complications using the Youden index. A P<0.05 was considered significant. Results: The total number of complications reached 44.8%. The most common complications included: migration of the male or female implant (45.7% and 25.7% out of the total number of complications, respectively), bone fracture with bending of the rod (8.6%), and rotational deformities (8.6%). Significant differences in patients’ ages at the time of surgery were found between the group with and without complications (P=0.04), while sex, segment treated, preceding surgeries, length of FU, FD rod diameter, and length of bisphosphonate treatment were not significant. The Youden index showed that the risk of complications rose significantly in patients treated when younger than 5.5 years of age (P<0.05). Conclusions: This series displays the effectiveness and utility of FD rods at a median FU of over 4 years. Complication rates were comparable with the existing literature, with a notable increase in the number of side effects observed in younger patients (below the age of 5). Level of Evidence: Level IV—therapeutic study.

Background The significantly accelerated development of human society in the last millennium has brought about changes in human behavior and body mass that may have influenced human bone morphology. Our objective was to analyze the variation in pelvic shape and size in males from modern and medieval populations. Methods We obtained 22 pelvic girdles of adult males from a medieval cemetery located in Cedynia, Poland. The control group comprised 31 contemporary male pelves from individuals inhabiting the same region. The analyzed parameters were: interspinous distance (ISD), intercristal distance (ICD), intertuberous distance (ITD), anatomic conjugate of the pelvis, height of the pelvis (HP), iliac opening angle (IOA), iliac tilt angle (ITA), and ISD/ITD/HP ratio. Geometric morphometrics was used to analyze differences in shape in the pelves. All analyses were carried out on three-dimensional CT reconstructions of pelves. Results ISD, ICD, and IOA were significantly greater in modern pelves than in those from Cedynia, but no significant differences were seen between the two groups in ITD, anatomical conjugate, HP, or ITA. ISD/ITD/HP ratios were significantly lower in the Cedynia group. Geometric morphometrics revealed significant differences in pelvic shape between the analyzed groups. Discussion The pelves of modern males are larger, wider, and flatter than those of medieval males. Changes in the set of daily activities that produce mechanical loading and estimated body mass may constitute the main factors explaining pelvic variability. However, differences in ontogenesis should also be taken into consideration, especially since growth in past populations is often found to be reduced relative to modern populations.

Background Cam morphology is thought to originate near puberty and reflects a response of the peripheral aspect of the proximal femoral physis to increased local load. Participation in particular sports activities has been associated with cam morphology in contemporary patient populations; however, it is unclear whether cam is a recent phenomenon. There are limited data regarding the frequency of its occurrence and the general deviations in femoral anatomy in different historical populations. Such information may help to understand the possible influence of lifestyle and diet on cam morphology. Questions/purposes The purpose of this study was to evaluate femoral morphology in three historical populations. We asked: (1) Was cam morphology present in the three study populations, did those populations differ, and were there differences between sexes? (2) Were there differences in neck-shaft angle, version, or inclination between and among the examined populations? Methods We examined 204 adult femurs from the Neolithic population from Iran (n = 37, 3000 BC to 1631 BC), medieval population from Poland (n = 135, 10th to 13th centuries), and contemporary Australian aborigines (n = 32, early 20th century), provided by the Open Research Scan Archive, Museum of the First Piasts at Lednica and the University of Wrocław, respectively. All three human populations represent different chronologic periods and lifestyles. All bones were scanned using CT and then measured on their three-dimensional (3-D) reconstructions in selected planes. Cam impingement was defined as an alpha angle > 55° measured on the inclination view. To evaluate the differences in anatomy between populations, we measured the true neck-shaft angle on the true AP view, apparent neck-shaft angle on the apparent AP view, the version angle on the version view, and the inclination angle on the inclination view. The prevalence of cam morphology and other anatomic parameters were compared among groups using chi-square test, one-way ANOVA with post hoc Tukey test, and paired t-test. Results Cam morphology was present in 5% of the Neolithic population from Iran, in 7% of the medieval population from Poland, and 3% of the contemporary Australian aborigine femurs (OR Neolithic population from Iran/the medieval population from Poland 0.7 [95% CI 0.2 to 3.4]; p = 0.67; OR Neolithic population from Iran/contemporary Australian aborigines 1.8 [95% CI 0.2 to 20.5]; p = 0.65; OR the medieval population from Poland/contemporary Australian aborigines 2.5 [95% CI 0.3 to 20.1]; p = 0.40). There were differences in the presence of cam morphology between the sexes in the medieval population from Poland with both femurs (females: 1% [1 of 76]; males: 15% [9 of 59]; p = 0.002). There was a difference in true neck-shaft angle between the Neolithic population from Iran (121° ± 6°) and contemporary Australian aborigines (131° ± 5°; mean difference 10° [95% CI 7° to 13°]; p < 0.001) and between the medieval population from Poland (124° ± 5°) and the contemporary Australian aborigines (mean difference 7° [95% CI 5° to 9°]; p < 0.001). Apparent neck-shaft angle differed between the Neolithic population from Iran (126° ± 6°) and the contemporary Australian aborigines (134° ± 5°; mean difference 8° [95% CI 6° to 11°]; p < 0.001), and between the medieval population from Poland (126° ± 6°) and the contemporary Australian aborigines (mean difference 9° [95% CI 7° to 11°]; p < 0.001). Moreover, we observed a difference in the version angle between the Neolithic population from Iran (19° ± 7°) and the medieval population from Poland (12° ± 9°; mean difference 7° [95% CI 4° to 10°]; p < 0.001] and in the inclination angle between aforementioned groups (18° ± 7° versus 11° ± 8°; mean difference 7° [95% CI 5° to 10°]; p < 0.001). Conclusion This study found that cam morphology existed in historical populations at rates comparable with a contemporary population. Clinical Relevance The presence of cam morphology in historical populations suggests that cam morphology can develop outside of the intense sports activity seen in modern adolescents. Further study will help elucidate the etiology of cam morphology, which may be useful in the development of preventive strategies.