No abstract

Bacteria‐driven biohybrid microswimmers (bacteriabots), which integrate motile bacterial cells and functional synthetic cargo parts (e.g., microparticles encapsulating drug), are recently studied for targeted drug delivery. However, adhesion of such bacteriabots to the tissues on the site of a disease (which can increase the drug delivery efficiency) is not studied yet. Here, this paper proposes an approach to attach bacteriabots to certain types of epithelial cells (expressing mannose on the membrane), based on the affinity between lectin molecules on the tip of bacterial type I pili and mannose molecules on the epithelial cells. It is shown that the bacteria can anchor their cargo particles to mannose‐functionalized surfaces and mannose‐expressing cells (ATCC HTB‐9) using the lectin–mannose bond. The attachment mechanism is confirmed by comparing the adhesion of bacteriabots fabricated from bacterial strains with or without type I pili to mannose‐covered surfaces and cells. The proposed bioadhesive motile system can be further improved by expressing more specific adhesion moieties on the membrane of the bacteria.

Bacteria-driven biohybrid microswimmers (bacteriabots) combine synthetic cargo with motile living bacteria that enable propulsion and steering. Although fabrication and potential use of such bacteriabots have attracted much attention, existing methods of fabrication require an extensive sample preparation that can drastically decrease the viability and motility of bacteria. Moreover, chemotactic behavior of bacteriabots in a liquid medium with chemical gradients has remained largely unclear. To overcome these shortcomings, we designed Escherichia coli to autonomously display biotin on its cell surface via the engineered autotransporter antigen 43 and thus to bind streptavidin-coated cargo. We show that the cargo attachment to these bacteria is greatly enhanced by motility and occurs predominantly at the cell poles, which is greatly beneficial for the fabrication of motile bacteriabots. We further performed a systemic study to understand and optimize the ability of these bacteriabots to follow chemical gradients. We demonstrate that the chemotaxis of bacteriabots is primarily limited by the cargo-dependent reduction of swimming speed and show that the fabrication of bacteriabots using elongated E. coli cells can be used to overcome this limitation.

There is a growing interest in transdermal delivery systems because of their noninvasive, targeted, and on-demand delivery of gene and drugs. However, efficient penetration of therapeutic compounds into the skin is still challenging largely due to the impermeability of the outermost layer of the skin, known as stratum corneum. Recently, there have been major research activities to enhance the skin penetration depth of pharmacological agents. This article reviews recent advances in the development of various strategies for skin penetration enhancement. We show that approaches such as ultrasound waves, laser, and microneedle patches have successfully been employed to physically disrupt the stratum corneum structure for enhanced transdermal delivery. Rather than physical approaches, several non-physical route have also been utilized for efficient transdermal delivery across the skin barrier. Finally, we discuss some clinical applications of transdermal delivery systems for gene and drug delivery. This paper shows that transdermal delivery devices can potentially function for diverse healthcare and medical applications while further investigations are still necessary for more efficient skin penetration of gene and drugs.

Calcium phosphate (CaP) is used for in vitro transfection because of low toxicity and simple and low cost synthesis. The transfection results however vary because the precipitation lacks reproducibility and results in polydispersed, agglomerated particles. Here a reproducible, one-step procedure for the preparation of amino-modified CaP nanoparticles (NPs) is described using N-(2-aminoethyl)-3-aminopropyltrimethoxysilane as modifying and dispersing agent. The aim was to produce homogeneous, stable CaP NPs, which are loaded with DNA after particle formation. The refined wet-precipitation method yielded NPs with a narrow size distribution (∼140 nm) and positive zeta potential at physiological pH. FTIR and Raman spectroscopy analysis verified the aminosilane modification. Interestingly two types of CaP crystalline structures, Brushite and Hydroxyapatite, can be produced depending on the pH and without hydrothermal treatment. Both CaP crystalline phases were characterized using X-ray diffraction (XRD), transmission electron microscopy (TEM), and Brunauer−Emmett−Teller (BET) analysis. Both showed very low toxicity and enabled reproducible transfection of A549 cells. The higher surface functionalization density of Brushite NPs led to superior pDNA condensation capability and higher transfection in lower NP concentration. The advantages of the improved synthesis are the achievement of stable, crystalline CaP NPs in higher yield and narrow distributed size achieved by agglomeration reduction even without hazardous surfactant.

Calcium phosphate system has been used widely in in vitro gene delivery for almost four decades. Excellent biocompatibility and simple application have motivated the researchers to always consider this system in their transfection experiments. However, there was a major drawback regarding the low transfection efficiency of calcium phosphate. Hence, there have been many efforts in order to increase the gene delivery potential of this system. In this paper, the application of calcium phosphate in gene delivery is introduced. Moreover, the recent progresses in the application of calcium phosphate in the delivery of (oligo)nucleotides and different approaches to improve the properties of this system are reviewed.

No abstract

Many methods have been developed in order to use calcium phosphate (CaP) for delivering nucleotides into living cells. Surface functionalization of CaP nanoparticles (CaP NPs) with N-(2-aminoethyl)-3-aminopropyltrimethoxysilane was shown recently to achieve dispersed NPs with a positive surface charge, capable of transfection (Chem. Mater. 2013, 25 (18), 3667). In this study, different crystal structures of amino-modified CaP NPs (brushite and hydroxyapatite) were investigated for their interaction in cell culture systems in more detail. Qualitative (confocal laser scanning microscopy) and quantitative (flow cytometry) transfection experiments with two cell lines showed the higher transfection efficacy of brushite versus hydroxyapatite. The transfection also revealed a cell type dependency. HEK293 cells were easier to transfect compared to A549 cells. This result was supported by the cytotoxicity results. A549 cells showed a higher degree of tolerance toward the CaP NPs. Further, the impact of the surface modification on the interaction with macrophages and complement as two important components of the innate immune system were considered. The amine surface functionalization had an effect of decreasing the release of proinflammatory cytokines. The complement interaction investigated by a C3a complement activation assay did show no significant differences between CaP NPs without or with amine modification and overall weak interaction. Finally, the degradation of CaP NPs in biological media was studied with respect to the two crystal structures and at acidic and neutral pH. Both amino-modified CaP NPs disintegrate within days at neutral pH, with a notable faster disintegration of brushite NPs at acidic pH. In summary, the fair transfection capability of this amino functionalized CaP NPs together with the excellent biocompatibility, biodegradability, and low immunogenicity make them interesting candidates for further evaluation.