Many different families of polymers are used in industries and engineering applications. The demands for studying the tribological behaviour of polymers and their composites are recently increased. This article briefs the most recent studies on the tribological behaviour of polymeric materials based on synthetic fibres. It reviews several factors which control the wear and frictional characteristics of such materials, that is, additives, fibres, interfacial adhesion, tribology environment, operating parameters, and composite geometry. In addition to that, new bioreinforcement (fibre) is introduced associated with preliminary results. The results showed that there is high potential of replacing the conventional reinforcement with the bioones.

No abstract

Recently, recycled thermoplastic polymers become an alternative resource for manufacturing industrial products. However, they have low mechanical properties compared to the thermosets. In this paper, an attempt has been made to enhance the mechanical properties of recycled high density polyethylene (HDPE) with chopped strand mat (CSM) glass fibres as a synthetic reinforcement and with short oil palm fibres as a biodegradable (natural) reinforcement. The effects of volume fraction of both synthetic and natural fibres on tensile, compression, hardness, and flexural properties of the HDPE were investigated. The failure mechanism of the composite was studied with the aid of optical microscopy. Tensile properties of the HDPE composites are greatly affected by the weight fraction of both the synthetic and the natural fibres. The higher strength of the composites was exhibited when at higher weight fraction of both natural and syntactic fibres which was about 50 MPa. Date palm fibre showed good interfacial adhesion to the HDPE despite the untreated condition used. On the other hand, treatment of the fibres is recommended for higher tensile performance of the composites.

The impact properties of neat vinyl ester and the nanocomposites were performed using a low velocity impact testing. The addition of layered silicate into the polymer matrix shows that an optimum range of nanoclay reinforcement in the vinyl ester matrix can produce enhanced load bearing and energy absorption capability compared to the neat matrix. In addition, the amount of microvoids in the nanocomposites structure influences the overall properties. Likewise, the influence of the clay addition into the neat polymer on the creep relaxation behaviour at 25°C and 60°C was studied. In both cases, the presence of the layered silicate remarkably improved the creep behaviour. The improvement of these properties can be assigned to the stiff fillers and the configurational linkage between the polymer and the layered silicate which are supported by scanning electron microscopy (SEM) and transmission electron microscopy (TEM) characterisations by showing a distinct change in surface morphology associated with improved impact toughness and creep response.

The aim of this work was to study the structure and mechanical properties of spent polyamide-12 and spent polyamide-12/layered silicate reinforced novel nanocomposites. Layered silicate at 1, 3, 5 and 7 wt.% was incorporated in spent polyamide-12 and its nanocomposites were prepared using single screw injection moulding technique. The interlamellar structure and surface morphology were characterised by transmission electron microscope (TEM) and scanning electron microscope (SEM). Different levels of layered silicate dispersion (as characterised by TEM and SEM) correlated strongly with improvements in mechanical performance. The results showed that the tensile and flexural properties are found to be increased with the incorporation of layered silicate into spent PA-12 matrix. Comparison of tensile and flexural test results between virgin PA-12, spent PA-12 and spent PA-12 nanocomposites showed that spent PA-12 samples have retained 70% of its tensile and 80% of its flexural properties respectively, compared to virgin PA-12.