No abstract

We present flattened convolutional neural networks that are designed for fast feedforward execution. The redundancy of the parameters, especially weights of the convolutional filters in convolutional neural networks has been extensively studied and different heuristics have been proposed to construct a low rank basis of the filters after training. In this work, we train flattened networks that consist of consecutive sequence of one-dimensional filters across all directions in 3D space to obtain comparable performance as conventional convolutional networks. We tested flattened model on different datasets and found that the flattened layer can effectively substitute for the 3D filters without loss of accuracy. The flattened convolution pipelines provide around two times speed-up during feedforward pass compared to the baseline model due to the significant reduction of learning parameters. Furthermore, the proposed method does not require efforts in manual tuning or post processing once the model is trained. INTRODUCTIONRecent success on fast implementation of convolutional neural networks (CNNs), and new techniques such as dropout enable researchers to train large networks that were not possible before. These large CNNs show great promise in visual and audio understanding which make them useful for applications in autonomous robots, security systems, mobile phones, automobiles and wearable supports. These applications require networks with high degree of accuracies, but also networks that can be executed in real-time. However, CNNs are computationally very expensive and require high performance servers or graphics processing units (GPUs).

Deep convolutional neural networks (DCNNs) have become a very powerful tool in visual perception. DCNNs have applications in autonomous robots, security systems, mobile phones, and automobiles, where high throughput of the feedforward evaluation phase and power efficiency are important. Because of this increased usage, many field-programmable gate array (FPGA)-based accelerators have been proposed. In this paper, we present an optimized streaming method for DCNNs' hardware accelerator on an embedded platform. The streaming method acts as a compiler, transforming a high-level representation of DCNNs into operation codes to execute applications in a hardware accelerator. The proposed method utilizes maximum computational resources available based on a novel-scheduled routing topology that combines data reuse and data concatenation. It is tested with a hardware accelerator implemented on the Xilinx Kintex-7 XC7K325T FPGA. The system fully explores weight-level and node-level parallelizations of DCNNs and achieves a peak performance of 247 G-ops while consuming less than 4 W of power. We test our system with applications on object classification and object detection in real-world scenarios. Our results indicate high-performance efficiency, outperforming all other presented platforms while running these applications.

Learning to synthesize high frame rate videos via interpolation requires large quantities of high frame rate training videos, which, however, are scarce, especially at high resolutions. Here, we propose unsupervised techniques to synthesize high frame rate videos directly from low frame rate videos using cycle consistency. For a triplet of consecutive frames, we optimize models to minimize the discrepancy between the center frame and its cycle reconstruction, obtained by interpolating back from interpolated intermediate frames. This simple unsupervised constraint alone achieves results comparable with supervision using the ground truth intermediate frames. We further introduce a pseudo supervised loss term that enforces the interpolated frames to be consistent with predictions of a pre-trained interpolation model. The pseudo supervised loss term, used together with cycle consistency, can effectively adapt a pre-trained model to a new target domain. With no additional data and in a completely unsupervised fashion, our techniques significantly improve pre-trained models on new target domains, increasing PSNR values from 32.84dB to 33.05dB on the Slowflow and from 31.82dB to 32.53dB on the Sintel evaluation datasets.

No abstract