No abstract

In order to scavenge the energy of ambient vibrations, bistable vibration energy harvesters constitute a promising solution due to their large frequency bandwidth. Because of their complex dynamics, simple models that easily explain and predict the behavior of such harvesters are missing from the literature. To tackle this issue, this paper derives simple analytical closed-form models of the characteristics of bistable energy harvesters (e.g., power-frequency response, displacement response, cut-off frequency of the interwell motion) by mean of truncated harmonic balance methods. Measurements on a bistable piezoelectric energy harvester illustrate that the proposed analytical models allow the prediction of the mechanical displacement and harvested power, with a relative error below 10%. From these models, the influences of various parameters such as the inertial mass, the acceleration amplitude, the electromechanical coupling, and the resistive load, are derived, analyzed and discussed. The proposed models and analysis give an intuitive understanding of the dynamics of bistable vibration energy harvesters, and can be exploited for their design and optimization.

Bistable piezoelectric energy harvesters are prominent solutions in the field of vibration energy harvesting due to their broadband behavior. However, the impact of the electrical interface and especially the load impedance needs to be addressed. In this study, the impact of the electrical load resistance on the dynamic of the bistable piezoelectric energy harvester has been studied. Through a parametric study, the present paper shows that the load resistance impacts both the harvested power and the bandwidth of the harvester. The analytical expression of the mass displacement, critical angular frequency and harvested power have been obtained, based on a truncated harmonic balance method. A comparison between the analytical model and experimental measurement on a custom bistable energy harvester is then presented. The experimental results are in good agreement with the analytical model, which proves the validity of the proposed model and analysis. The results presented in this study should be considered in the development of maximum power point tracking algorithms and orbit jump strategies.

HAL is a multi-disciplinary open access archive for the deposit and dissemination of scientific research documents, whether they are published or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers. L'archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau recherche, publiés ou non, émanant des établissements d'enseignement et de

This paper presents a model suited for the design of mechanically bistable beams used in Piezoelectric EnergyHarvesters (PEHs). The proposed model accounts for the bending and compression of post-buckled beams used in the PEH. The effect of the beam's geometry on the generated power and frequency bandwidth is evaluated with a performance criterion. It is concluded that a low beam compression stiffness can have a negative impact on the performance of the PEH and that the bending stiffness solely implies a prestress on the piezoelectric transducer.