No abstract

No abstract

No abstract

No abstract

No abstract

No abstract

Summary The optimization of the performance of electrodes (oxide‐based) for composite electrolytes (Ce0.9Gd0.1O1.95 + (Li0.52Na0.48)2CO3) is addressed in this work acting mostly on the electrode chemical nature (eg, LaCoO3, Li0.43NiO2, or LiNiO2), thickness (single and multiple screen‐printed layers), and cell layer concept (with/without barrier layers between electrode and electrolyte). The cell performance and stability were analyzed by electrochemical impedance spectroscopy, X‐ray diffraction, scanning electron microscopy, and energy dispersive spectroscopy. LaCoO3 electrodes deposited on the electrolyte using an intermediate barrier layer showed a promising area specific resistance of 0.22 Ω.cm2 at 600°C. This optimized cell processing route was adopted as reference to study the endurance performance of distinct electrode materials up to 100 hours in air, at 550°C, where lithiated NiO showed the best stability.

Solution combustion synthesis technique is one of the novel techniques used to prepare nanoparticles, multi-component ceramic oxides and nanocomposites with properties better than conventionally prepared one and these materials have been used for various applications such as sensors, catalysts, and materials for solid oxide fuel cell (SOFCs). In the present work, the method has been used to prepare nanoparticles of 10 mol% Gd doped ceria (GDC) and Cu and its oxides. The oxidant to fuel (O/F) ratio is found to affect the powder properties and even compositional homogeneity. In glycine-nitrate combustion synthesis of GDC, as revealed by XRD studies, phase pure nanoparticles with crystallite size in the range 9-12nm were obtained for all the O/F ratios. TEM measurements of calcined powder showed hexagonal shaped particles of roughly 20nm size. The exothermicity was increased with the oxidant to fuel ratio resulting in high surface area and soft agglomerates. A slightly lean O/F ratio gives surface area of 73 m2/g and soft agglomerates (D50= 5.34 mm), which eventually results into high sintering density at low temperature. Raman Spectra of GDC showed a sharp and intense peak at 467 cm−1which corresponds to CeO2due to F2gsymmetry of the cubic phase. In combustion synthesis of copper nitrate and citirc acid, the compositional homogenity and phase purity was affected by the oxidant to fuel ratio. The combustion at stoichiometric O/F ratio gives Cu nano particles, lean O/F ratio gives nanoparticles of Cu, CuO and Cu2O and rich ratio gives pure CuO nanoparticles. These nanoparticles have been studied with different characterization techniques like XRD, TG-DTA, SEM, TEM, FT-IR and Raman.