Basketball players usually score points during the game using the jump shot. For this reason, the jump shot is considered to be the most important element of technique in basketball and requires a high level of performance. The aim of this study was to compare the biomechanical characteristics of the lower limbs during a jump shot without the ball and a countermovement jump without an arm swing. The differences between variables provide information about the potential that an athlete can utilise during a game when performing a jump shot. The study was conducted among 20 second-league basketball players by means of a Kistler force plate and the BTS SMART system for motion analysis. The variables measured included the take-off time, mean power, peak power, relative mean power, jump height, maximum landing force and calculated impact ratio. Surprisingly, more advantageous variables were found for the jump shot. This finding suggests a very high performance level in the jump shot in the studied group and a maximum utilisation of their motor abilities. Both types of jumps were characterised by high mean and peak power values and average heights. The high forces at landing, which result in considerable impact ratios, may have prompted the studied group to land softly. Use of the countermovement jump without an arm swing is recommended to assess and predict the progression of player’s jumping ability.

The basic drill of plyometric training aimed at improving lower limb power and jump height is a drop jump. This exercise can be performed using different techniques, which substantially affects jump variables. Therefore, the aim of this study was to compare the values of the reactive strength index (RSI) for countermovement drop jumps (CDJs) and bounce drop jumps (BDJs). The study was carried out in a group of 8 male youth basketball players. The tests were conducted using the AMTI BP600900 force plate to measure ground reaction forces and the Noraxon MyoMotion system to record kinematic data. Each player performed two CDJs and two BDJs from the height of 15, 30, 45 and 60 cm. The RSI was calculated as a ratio of jump height and contact time. Moreover, the RSI was determined for the amortization and take-off phases separately. Significant differences (p < 0.05) between RSI values for CDJs and BDJs were recorded for jumps from 30, 45 and 60 cm. Differences in RSI values for jumps from 15 cm were not significant. Furthermore, CDJ height values were significantly higher (p < 0.05) than the values recorded for BDJs. Times of contact, amortization and take-off during BDJs were significantly shorter (p < 0.05) than the respective values obtained for CDJs. Therefore, the use of the RSI to monitor plyometric training should be based on the drop jump technique that is commonly performed by basketball players.

The ability to reach a high running velocity over a short distance is essential to a high playing performance in team games. The aim of this study was to determine the relationship between running time over a 10-meter section of a 30-meter sprint along a straight line and changes in the angle and angular velocity that were observed in the ankle, knee, and hip joints. The possible presence may help to optimize motion efficiency during acceleration sprint phase. Eighteen girls involved in team sports were examined in the study. The Fusion Smart Speed System was employed for running time measurements. The kinematic data were recorded using the Noraxon MyoMotion system. Statistically significant relationships were found between running time over a 10-meter section and the kinematic variables of hip and ankle joints. An excessively large flexion in hip joints might have an unfavorable effect on running time during the acceleration phase. Furthermore, in order to minimize running time during the acceleration phase, stride should be maintained along a line (a straight line) rather than from side to side. It is also necessary to ensure an adequate range of motion in the hip and ankle joints with respect to the sagittal axis.

Amputee soccer is one of the types of soccer designed for the disabled, especially those who have undergone amputations, as well as those with extremity dysfunction. The objective of the study was to find the relationship between hand grip strength and sprint time in amputee soccer players. Thirteen field amputee soccer players participated in the study. A SAEHAN hydraulic hand dynamometer manufactured by Jamar was used for hand grip strength measurements. The sprint running test was conducted over a distance of 30 m. The Fusion Smart Speed System was employed for running time measurements. No statistically significant relationships were found between hand grip strength of the left or right hand, and sprint times over 1, 5, 10, 15, 20, 25 and 30 m. Analysis of the running velocity curve of the subjects showed an interesting profile characterized by a 15 meter-long acceleration phase and a significant velocity increase over a distance of 20 – 25 m. The study suggests that there is no relationship between hand grip strength and sprint effectiveness in amputee soccer players. The specificity of locomotion with the use of elbow crutches among elite Polish amputee soccer players probably accounts for the profile of the sprint velocity curve. Extension of the acceleration phase in the sprint run and a velocity increase in the subsequent part of the run were observed.

Stiffness, the resistance to deformation due to force, has been used to model the way in which the lower body responds to landing during cyclic motions such as running and jumping. Vertical, leg, and joint stiffness provide a useful model for investigating the store and release of potential elastic energy via the musculotendinous unit in the stretch-shortening cycle and may provide insight into sport performance. This review is aimed at assessing the effect of vertical, leg, and joint stiffness on running performance as such an investigation may provide greater insight into performance during this common form of locomotion. PubMed and SPORTDiscus databases were searched resulting in 92 publications on vertical, leg, and joint stiffness and running performance. Vertical stiffness increases with running velocity and stride frequency. Higher vertical stiffness differentiated elite runners from lower-performing athletes and was also associated with a lower oxygen cost. In contrast, leg stiffness remains relatively constant with increasing velocity and is not strongly related to the aerobic demand and fatigue. Hip and knee joint stiffness are reported to increase with velocity, and a lower ankle and higher knee joint stiffness are linked to a lower oxygen cost of running; however, no relationship with performance has yet been investigated. Theoretically, there is a desired “leg-spring” stiffness value at which potential elastic energy return is maximised and this is specific to the individual. It appears that higher “leg-spring” stiffness is desirable for running performance; however, more research is needed to investigate the relationship of all three lower limb joint springs as the hip joint is often neglected. There is still no clear answer how training could affect mechanical stiffness during running. Studies including muscle activation and separate analyses of local tissues (tendons) are needed to investigate mechanical stiffness as a global variable associated with sports performance.

No abstract

The impact of the hamstrings-to-quadriceps ratio on sport movement performance has not been sufficiently described. However, it seems that in movements involving eccentric-concentric muscular contractions, a higher hamstrings-to-quadriceps ratio should have a positive impact on human movement performance. The present study is aimed at identifying relationships between the hamstrings-to-quadriceps ratio and variables describing countermovement and drop jumps. The study was carried out in a group of 14 female soccer players. The tests were conducted using a Kistler force plate, an SG electrogoniometer, and the Biodex System 4 Pro dynamometer. Each player performed three countermovement jumps (CMJ) and three drop jumps (DJ) from heights of 15, 30, 45, and 60 cm. The peak torques of knee extensors and flexors were measured in isometric conditions and in isokinetic conditions at angular velocities of 30o/s, 60o/s, 90o/s, and 120o/s. Statistically significant relationships were found between the variables that describe CMJ, DJ 15, DJ 30, and hamstrings-to-quadriceps ratio at some, though not all, of the angular velocities measured. No significant relationships were found between the hamstrings-to-quadriceps ratio and variables that describe DJ 45 and DJ 60. The heights of CMJ, DJ 15, and DJ 30 were increased with higher hamstrings-to-quadriceps ratios. Analogous relationships were found between the hamstrings-to-quadriceps ratio and relative mechanical power during the take-off phase of the CMJ. Significant relationships between the hamstrings-to-quadriceps ratio and variables that describe vertical jump are likely to be observed if adequate angular velocity is used in the measurement of muscle torque.

Objective. Intermittent claudication (IC) is a pathological symptom with a particular effect on human gait patterns. Therefore, analyzing these patterns can facilitate rehabilitation or treatment through comparison of the values of kinematic and kinetic variables of patients with the normal values of healthy people. Therefore, the aim of this study was to find differences in the values of gait variables between patients with IC and healthy people. Methods. The study included 98 patients diagnosed with peripheral arterial disease with IC. The patients traveled a distance of 6 m at a voluntary gait velocity. Ground reaction forces while the foot contacted the ground and kinematic variables of lower limb movements were recorded. The values of normal gait variables were computed based on the results obtained in a group of 30 healthy people. Results. Patients used a gait velocity below the norm for healthy people. The velocity during the lower limb swing and the step and stride length in patients with IC were below the norm. Differences were also found in the ranges of motion between patients with IC and healthy people for the pelvic obliquity, pelvic rotation, hip flexion-extension, hip abduction-adduction, hip internal-external rotation, knee flexion-extension, ankle dorsi-plantar flexion, and foot progression angles. Conclusions. The presented kinematic and kinetic characteristics measured by gait variables suggest differences between patients with IC and healthy people. Considering kinematic and kinetic gait variables during the rehabilitation process would facilitate the development of a more economic gait technique (with increased stride length and range of motion in the lower limb joints) to obtain the desired rehabilitation effects. Patients with IC should receive rehabilitation oriented towards improving mobility and increasing muscle strength in selected lower limb joints to increase gait velocity and stride length.