Esse artigo aborda a influência da configuração geométrica inicial na carga-limite de portais planos de aço, determinada empregando-se uma análise inelástica de segunda ordem baseada na aplicação do método da zona plástica. Essa configuração geométrica inicial inclui imperfeições como a curvatura inicial e o fora de prumo, que fazem parte dos requerimentos mínimos para se qualificar essa análise inelástica como avançada. Os passos necessários para desenvolver essa análise serão mostrados, incluindo a formulação, as exigências de cálculo e os exemplos utilizados nesse estudo. Finalmente, são apresentados as conclusões e um roteiro de análise, que podem auxiliar o engenheiro a estabelecer a configuração inicial mais crítica, a partir da qual pode-se determinar a carga-limite de um problema estrutural mais complexo. This paper studies the contribution of initial geometric configuration to the limit load defined by a second-order plastic-zone inelastic analysis applied to steel plane frames. This initial configuration must include geometric imperfections (out-of-straightness and out-of-plumb) that are required for qualifying the inelastic analysis as advanced one. The necessary steps to apply this analysis are shown, including formulation, requirements and the studied examples. Lastly, a step-by-step procedure and a conclusion are given, providing the critical initial configuration by which the engineer will define the limit load for more complex structural problems
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.