No abstract

No abstract

Image registration is an important step in the radiotherapy treatment planning process. It provides a method of fusing different types of diagnostic imaging information. One such application is to combine magnetic resonance spectroscopic images (MRSI) of the prostate with anatomical MRI and/or computed tomography images that are routinely used in the radiation treatment planning of prostate cancer. MRSI provides in vivo information related to the underlying metabolic activity of tissues, and can be related to the presence of cancer. However, the inflated endorectal coil required during MRS imaging poses a potential problem by deforming the prostate when it is filled with approximately 100 cm3 of air during image acquisition. This pushes the prostate superiorly/anteriorly, deforming the prostate and consequently the spectroscopic imaging data in a nonlinear manner. In this application, the coil-deformed MRS images are warped back to a non-deformed state, using a single data set. A nonlinear warping algorithm is presented to achieve this. Results indicate that the algorithm attains an accuracy of 97% (4 cm3 difference) when reproducing the total prostate volume compared to a Radiation Oncologist defined prostate volume. This difference is slightly smaller than the measured intra-operator variance of +/-1.5 cm3 (deflated coil) and the measured algorithm variance of +/-1.0 cm3. Additionally, intraprostatic nodules were used to assess the accuracy of the warping algorithm in regions inside the prostate. While choosing anatomical tie points along the external prostate surface, analysis of the nodules revealed the algorithm accuracy reduced to 63-93%.

PurposeThree-dimensional printing has been implemented at our institution to create customized treatment accessories, including lead shields used during radiation therapy for facial skin cancer. To effectively use 3-dimensional printing, the topography of the patient must first be acquired. We evaluated a low-cost, structured-light, 3-dimensional, optical scanner to assess the clinical viability of this technology.Methods and materialsFor ease of use, the scanner was mounted to a simple gantry that guided its motion and maintained an optimum distance between the scanner and the object. To characterize the spatial accuracy of the scanner, we used a geometric phantom and an anthropomorphic head phantom. The geometric phantom was machined from plastic and included hemispherical and tetrahedral protrusions that were roughly the dimensions of an average forehead and nose, respectively. Polygon meshes acquired by the optical scanner were compared with meshes generated from high-resolution computed tomography images. Most optical scans contained minor artifacts. Using an algorithm that calculated the distances between the 2 meshes, we found that most of the optical scanner measurements agreed with those from the computed tomography scanner within approximately 1 mm for the geometric phantom and approximately 2 mm for the head phantom. We used this optical scanner along with 3-dimensional printer technology to create custom lead shields for 10 patients receiving orthovoltage treatments of nonmelanoma skin cancers of the face. Patient, tumor, and treatment data were documented.ResultsLead shields created using this approach were accurate, fitting the contours of each patient's face. This process added to patient convenience and addressed potential claustrophobia and medical inability to lie supine.ConclusionsThe scanner was found to be clinically acceptable, and we suggest that the use of an optical scanner and 3-dimensional printer technology become the new standard of care to generate lead shielding for orthovoltage radiation therapy of nonmelanoma facial skin cancer.