By releasing of azo dye through textile effluent, textile industry is the main cause of water pollution resulting into acute effect on environment and human health. Development of any eco-friendly and cost-effective method that may address the drawbacks to physical or chemical methods of dye removal is the recent global priority. Physical or chemical methods for textile wastewater pretreatment are of high cost, extremely energy consuming, and environmentally low efficient and generate toxic sludge. Thus, the use of microbial technique for textile dye degradation will be eco-friendly and is probably a lucrative alternative to physico-chemical processes. Microbial enzymes, viz. laccase and azoreductase, are cost-efficient, easy to harvest, easily downstream processable, and effortlessly mobilizable. Recent research trends on nanoparticle-microbial enzyme conjugates are also highly efficient to remove the azo dye from textile waste within a few minutes. But unfortunately, due to some gap between academia and industry, these methods remain only limited up to laboratory and its industrialization is still a challenge. The present review is an illustrated compilation of the use of microbial enzymes in removal of textile dyes.

No abstract

Testing of groundwater used for drinking for arsenic has been undertaken more widely by state governments in several states of India in recent years with the support of UNICEF. Available data for five states are collated in this paper and this provides the most up-to-date picture of areas known to be affected by arsenic in groundwater in the Indian portion of the Ganges-Brahmaputra river basin. In West Bengal, water from 132,262 government installed handpumps in 8 districts has been tested and overall 25.5% of samples were found to contain arsenic at concentrations greater than 50 microgL(-1) and 57.9% at concentrations greater than 10 microgL(-1). On the banks of the Brahmaputra in Assam, to date, samples from 5,729 government handpump sources in 22 districts have been tested for arsenic. Overall, samples from 6.3% of sources were found to contain arsenic at concentrations greater than 50 microgL(-1) and 26.1% at concentrations greater than 10 microgL(-1). In Bihar, on the River Ganges upstream of West Bengal, 66,623 sources from 11 districts have been tested and water samples from 10.8% of sources were found to contain arsenic at concentrations greater than 50 microgL(-1) and 28.9% at concentrations greater than 10 microgL(-1). Upstream of Bihar in Uttar Pradesh, home of the Taj Mahal, to date water samples from 20,126 government-installed handpump sources have been tested. As a result 2.4% of the samples tested were found to contain arsenic at concentrations greater than 50 microgL(-1) and 21.5% at concentrations greater than 10 microgL(-1). Finally in one district of Jharkhand, lying on the Ganges alluvial plain between Bihar and West Bengal, 9,007 sources have been tested and water samples from 3.7% of sources were found to contain arsenic at concentrations greater than 50 microgL(-1) and 7.5% at concentrations greater than 10 microgL(-1). State governments have adopted different sampling strategies and these are described in this paper. Testing is ongoing in several states and the complete picture is yet to emerge in some areas.

Pure and drinkable water will be rarer and more expensive as the result of pollution induced by industrialisation, urbanisation and population growth. Among the numerous sources of water pollution, the textile industry has become a major issue because effluents containing dyes are often released in natural water bodies. For instance, about two years are needed to biodegrade dye-derived, carcinogenic aromatic amines, in sediments. Classical remediation methods based upon physicochemical reactions are costly and still generate sludges that contain amine residues. Nonetheless, recent research shows that nanomaterials containing biopolymers are promising to degrade organic pollutants by photocatalysis. Here, we review the synthesis and applications of biopolymeric nanomaterials for photocatalytic degradation of azo dyes. We focus on conducting biopolymers incorporating metal, metal oxide, metal/metal oxide and metal sulphide for improved biodegradation. Biopolymers can be obtained from microorganisms, plants and animals. Unlike fossil-fuel-derived polymers, biopolymers are carbon neutral and thus sustainable in the context of global warming. Biopolymers are often biodegradable and biocompatible.

No abstract

Pseudomonas aeruginosa was identified as a facultative pathogen of red palm weevil. Intra-haemocoelic injection of the pathogen within larvae and pre-pupae was more effective at killing the insects [with a median lethal dose (LD50) of 9×10(2) to 2×10(3) bacteria/insect] than inoculation by force feeding (LD50 of 10(5) to 4×10(5) bacteria/insect) or by wading the insects in a suspension of the pathogen (LD50 of 10(5) to 2×10(5) bacteria/insect). Injection of 3×10(3) bacteria/insect killed 69% of larvae; small larvae were more susceptible (LD50 of 9×10(5) bacteria/larva) than either larger larvae (LD50 of 10(3) bacteria/larva) or pre-pupa. The median time to death of the small larvae following injection of P. aeruginosa was about 6 days but that following force feeding or wading was about 8 days. A secondary invader, Serratia marcescens, had no effect on the pathogenicity of P. aeruginosa but hastened death of larvae by about 3 days.

The exopolysaccharide succinoglycan is produced mainly by a large number of soil microbes of , or genera etc. Structural properties of succinoglycan are unique in terms of its thermal stability and superior viscosifying property. Unlike the other highly commercialized bacterial exopolysaccharides like dextran or xanthan, mass scale application of succinoglycan has not been that much broadly explored yet. Bacterial succinoglycan is found suitable as a viscosifying and emulsifying agent in food industry, in gravel packing or fluid-loss control agent etc. In this present review, the key aspects of succinoglycan study, in particular, developments in structural characterizations,/ operon system involved in biosynthesis pathway, commercial applications in food and other industries and patenting trends have been discussed.

Xylans are the second most abundant form of hemicelluloses and are the second most abundant polysaccharide in nature after cellulose. To degrade xylan, microbes produce mainly xylanase enzyme. Wide range of microorganisms like fungi, bacteria, yeast, marine algae etc. are capable of producing xylanase. Main source of xylanase is fungi but industrial production of bacterial xylanase is low cost, easy downstream process and high production rate. To understand primary, secondary and tertiary structure of xylanase, in silico composition of amino acids, basic physiological characteristics; viz ., pI, molecular weight, instability index, GRAVY, molar extinction coefficient, secondary structure, presence of functional domain and motifs, phylogenetic tree, salt bridge compositions are determined. In silico study of xylanase focused on 36 different bacterial sources are performed by retrieving FASTA and PDB sequences using RCSB PDB. FASTA and PDB files are proceed further in ExPASy-ProtParam, RAMPAGE, QMEAN, MEME, PSIPRED, InterProScan, MOTIF scan, ERRAT, Peptide cutter, ESBRI and MEGA 7. The instability index range (16.90–38.78) clearly indicates that the protein is highly stable. α- helix mean value (27.11%) infers the protein is dominated by α- helix region. The aliphatic index (39.80–90.68) gives information that the protein is highly thermostable, prevalence by alanine amino acid in aliphatic side chain. No transmembrane domain was found in the protein which confirms the enzyme is extracellular in nature. Ancestor chart analysis confirmed that it is a part of carbohydrate metabolic process and more specifically a member of glycoside hydrolase super family.