Raman scattering is an excellent tool to characterize nanocrystalline clusters and the structural arrangement of carbon atoms in carbon‐based materials. Diamond‐like carbon (DLC) films are used in many industrial applications due to their hardness, wear resistance and biological compatibility. The properties of DLC coatings depend on the carbon coordination and incorporation of other elements, influences onto their Raman spectra will be reviewed.

No abstract

No abstract

For the first time, biocarbon reinforced polylactide (PLA) filaments were available for the 3D printing. Biocarbon is the carbon obtained from trees, plants, and soils to naturally absorb and store carbon dioxide from the atmosphere. One of the most important features is renewability. Because of this, it has been decided to reinforce PLA with biocarbon to obtain 100% recyclable material. Although PLA has been used in 3D printing for a long time, more applications like housings or structural interior of automobiles or other vehicles can be realised, if the mechanical and tribological properties are improved. Because the new PLA/biocarbon reinforced composites are degradable, they can be used as soil improvement after end of life as a structural material. The filaments were produced by compounding the biocarbon with polylactide granulate. Biocarbon was produced by pyrolysis of wheat stems at 800 ∘ C. The biomass were collected from different regions in Germany, Europe. As shown by Raman spectroscopy, the in-plane crystallite size of pyrolysed wheat stems from different regions is almost similar and amounts to 2.35 ±0.02 nm. Biocarbon particles were successfully integrated into the polylactide. Filaments of 1.75 mm diameter were produced for 3D (3-dimensional) printing. Filaments with 5 vol.-%, 15 vol.-%, and 30 vol.-% biocarbon were extruded. The fused deposition modelling (FDM) printing process was slightly hindered at higher biocarbon loading. Based on optical and scanning electron microscopy, a very homogeneous particle distribution can be observed. Single carbon particles stick out of the filament surface, which may be a reason for enhanced nozzle wear during 3D printing. Friction is more stable for 30 vol.-% reinforced PLA in comparison to unreinforced PLA and composites with lower particle fraction. This effect could be caused by some topographical effects due to void generation at the surface of PLA with 30 vol.-% biocarbon. In general, the tribological resistance increases with higher volume fraction of biocarbon.

No abstract

No abstract

No abstract

No abstract