We describe a major advance in scanning ion conductance microscopy: a new hopping mode that allows non-contact imaging of the complex surfaces of live cells with resolution better than 20 nm. The effectiveness of this novel technique was demonstrated by imaging networks of cultured rat hippocampal neurons and mechanosensory stereocilia of mouse cochlear hair cells. The technique allows studying nanoscale phenomena on the surface of live cells under physiological conditions.There is a great interest in developing methods to image live cells at nanoscale resolution. Scanning probe microscopy (SPM) is one approach to this problem and both atomic force microscopy (AFM) and scanning electrochemical microscopy (SECM) have been used to image live cells 1,2 . However, deformation of the soft and responsive cell by AFM cantilever, particularly when imaging eukaryotic cells, represents a substantial problem for AFM. SECM, in contrast, involves no physical contact with the sample but a true topographic imaging of the convoluted surface of living cells with nanoscale resolution has not been yet achieved. Scanning ion conductance microscopy (SICM) 3 is another form of SPM, that allows imaging of the cell surface under physiological conditions without physical contact and with a resolution of 3-6 nm 4,5 . However, until now, SICM was restricted to imaging relatively flat surfaces, like all other SPM techniques. This is because when the probe encounters a vertical structure, it inevitably collides with the specimen (Fig. 1a). Here we report a novel mode of SICM that allows imaging of even the most convoluted surface structures at the nanoscale. SICM is based on the phenomenon that the ion flow through a sharp fluid-filled nanopipette is partially occluded when the pipette approaches the surface of a cell 3 . In conventional SICM a nanopipette is mounted on a three-dimensional piezo and automatic feedback control moves the pipette up or down to keep the pipette current at a constant level (the set point), while the sample is scanned in X-Y directions. Thus, a pipette-sample separation, typically equal to the pipette's inner radius, is maintained during imaging. In our hopping probe ion conductance microscopy (HPICM), we no longer use continuous feedback. Instead, at each imaging point, the pipette approaches the sample from a starting position that is above any of the surface features (Fig. 1b). The reference current is measured while the pipette is well away from the surface. The pipette then approaches until the current is reduced by a predefined amount, usually 0.25-1%. The Z-position when the current achieves this reduction is recorded as the height of the sample at this imaging point. Typically, even at a 1% reduction of the current, the pipette is still at a distance of about one inner pipette radius from the surface. Therefore, the probe never touches the surface of the cell. The pipette is then withdrawn away from the surface and the sample moved laterally to determine the next imaging point. By continuously upd...

access under the following conditions. Copyright © and all moral rights to the version of the paper presented here belong to the individual author(s) and/or other copyright owners. To the extent reasonable and practicable the material made available in WRAP has been checked for eligibility before being made available. Copies of full items can be used for personal research or study, educational, or not-forprofit purposes without prior permission or charge. Provided that the authors, title and full bibliographic details are credited, a hyperlink and/or URL is given for the original metadata page and the content is not changed in any way.

We described a hybrid system of scanning electrochemical microscopy (SECM) and scanning ion conductance microscopy (SICM) with ion current feedback nanopositioning control for simultaneous imaging of noncontact topography and spatial distribution of electrochemical species. A nanopipette/nanoring electrode probe provided submicrometer resolution of the electrochemical measurement on surfaces with complex topology. The SECM/SICM probe had an aperture radius of 220 nm. The inner and outer radii of the SECM Au nanoring electrode were 330 and 550 nm, respectively. Characterization of the probe was performed with scanning electron microscopy (SEM), cyclic voltammetry (CV), and approach curve measurements. SECM/SICM was applied to simultaneous imaging of topography and electrochemical responses of enzymes (horse radish peroxidase (HRP) and glucose oxidase (GOD)) and single live cells (A6 cells, superior cervical ganglion (SCG) cells, and cardiac myocytes). The measurements revealed the distribution of activity of the enzyme spots on uneven surfaces with submicrometer resolution. SECM/SICM acquired high resolution topographic images of cells together with the map of electrochemical signals. This combined technique was also applied to the evaluation of the permeation property of electroactive species through cellular membranes.

We describe voltage-switching mode scanning electrochemical microscopy (VSM-SECM), in which a single SECM tip electrode was used to acquire high-quality topographical and electrochemical images of living cells simultaneously. This was achieved by switching the applied voltage so as to change the faradaic current from a hindered diffusion feedback signal (for distance control and topographical imaging) to the electrochemical flux measurement of interest. This imaging method is robust, and a single nanoscale SECM electrode, which is simple to produce, is used for both topography and activity measurements. In order to minimize the delay at voltage switching, we used pyrolytic carbon nanoelectrodes with 6.5-100 nm radii that rapidly reached a steady-state current, typically in less than 20 ms for the largest electrodes and faster for smaller electrodes. In addition, these carbon nanoelectrodes are suitable for convoluted cell topography imaging because the RG value (ratio of overall probe diameter to active electrode diameter) is typically in the range of 1.5-3.0. We first evaluated the resolution of constant-current mode topography imaging using carbon nanoelectrodes. Next, we performed VSM-SECM measurements to visualize membrane proteins on A431 cells and to detect neurotransmitters from a PC12 cells. We also combined VSM-SECM with surface confocal microscopy to allow simultaneous fluorescence and topographical imaging. VSM-SECM opens up new opportunities in nanoscale chemical mapping at interfaces, and should find wide application in the physical and biological sciences.high-resolution imaging | living cell imaging | noninvasive | constant-distance mode S canning electrochemical microscopy (SECM) uses an electrode tip for detecting electroactive chemical species and is an effective tool for the investigation of the localized chemical properties of sample surfaces and interfaces (1). Because SECM has high temporal resolution and can be used under physiological conditions, it is particularly well suited for quantitative measurements of (short-lived) chemicals like neurotransmitters, nitric oxide, reactive oxygen species, and oxygen, which are released/ consumed by living cells. In conventional SECM, the probe is often micrometer scale and the probe vertical position is kept at a constant height, a plane, during probe scanning. If the sample topography is not flat, the electrode-sample separation changes during scanning, complicating the SECM measurement and its analysis.Various methods for SECM electrode miniaturization and control of the electrode-sample separation have been advocated in order to improve the resolution of SECM imaging. The reliable fabrication of nanoelectrodes with a small ratio of electrodeinsulation to active electrode (

We have developed a distance modulated protocol for scanning ion conductance microscopy to provide a robust and reliable distance control mechanism for imaging contracting cells. The technique can measure rapid changes in cell height from 10 nm to several micrometers, with millisecond time resolution. This has been demonstrated on the extreme case of a contracting cardiac myocyte. By combining this method with laser confocal microscopy, it was possible to simultaneously measure the nanometric motion of the cardiac myocyte, and the local calcium concentration just under the cell membrane. Despite large cellular movement, simultaneous tracking of the changes in cell height and measurement of the intracellular Ca2+ near the cell surface is possible while retaining the cell functionality.

Do not touch! The surface of a living cell is soft and responsive and therefore high‐resolution imaging of the cell membrane has not been possible to date. Now noncontact imaging of protein complexes in the plasma membrane of living cells has been demonstrated (see picture) and has been used to follow the cells' structural reorganization. This breakthrough opens up a wealth of new experiments in membrane and cell biology.

Owing to their ability to efficiently deliver biological cargo and sense the intracellular milieu, vertical arrays of high aspect ratio nanostructures, known as nanoneedles, are being developed as minimally invasive tools for cell manipulation. However, little is known of the mechanisms of cargo transfer across the cell membrane‐nanoneedle interface. In particular, the contributions of membrane piercing, modulation of membrane permeability and endocytosis to cargo transfer remain largely unexplored. Here, combining state‐of‐the‐art electron and scanning ion conductance microscopy with molecular biology techniques, it is shown that porous silicon nanoneedle arrays concurrently stimulate independent endocytic pathways which contribute to enhanced biomolecule delivery into human mesenchymal stem cells. Electron microscopy of the cell membrane at nanoneedle sites shows an intact lipid bilayer, accompanied by an accumulation of clathrin‐coated pits and caveolae. Nanoneedles enhance the internalization of biomolecular markers of endocytosis, highlighting the concurrent activation of caveolae‐ and clathrin‐mediated endocytosis, alongside macropinocytosis. These events contribute to the nanoneedle‐mediated delivery (nanoinjection) of nucleic acids into human stem cells, which distribute across the cytosol and the endolysosomal system. This data extends the understanding of how nanoneedles modulate biological processes to mediate interaction with the intracellular space, providing indications for the rational design of improved cell‐manipulation technologies.

We present a new, general method for the controlled deposition of biological molecules on surfaces, based on a nanopipet operating in ionic solution. The potential applied to the pipet tip controls the flux of biological molecules from the pipet, allowing fine control of the delivery rate. We used the ion current to control the distance of the pipet from the surface of a glass slide and deposited the fluorescently labeled DNA or protein G at a defined location onto the surface. Features of 830 nm size were obtained by depositing the biotinylated DNA onto a streptavidin surface; 1.3 mum size spots were obtained by depositing protein G onto a positively charged glass surface.