Both daily and seasonal fluctuations of renewable power sources will require large-scale energy storage technologies. A recently developed integrated battery and electrolyzer system, called battolyser, fulfills both time-scale requirements. Here, we develop a macroscopic COMSOL Multiphysics model to quantify the energetic efficiency of the battolyser prototype that, for the first time, integrates the functionality of a nickel−iron battery and an alkaline electrolyzer. The current prototype has a rated capacity of 5 Ah, and to develop a larger, enhanced system, it is necessary to characterize the processes occurring within the battolyser and to optimize the individual components of the battolyser. Therefore, there is a need for a model that can provide a fast screening on how the properties of individual components influence the overall energy efficiency of the battolyser prototype. The model is validated using experimental results, and new configurations are compared, and the energy efficiency is optimized for the scale-up of this lab-scale device. Based on the modeling work, we find an optimum electrode thickness for the nickel electrode of 3 and 2.25 mm for the iron electrode with optimal electrode porosities in the range of void fraction of 0.15−0.35. Additionally, electrolyte conductivity and the gap thickness are found to have a small effect on the overall efficiency of the device.
-One of the main problems of renewable energies is storage of the energy carrier. For long-term storage, solar fuels seem to be a good option. Direct solar water splitting could play an important role in the production of these solar fuels. One of the main challenges of this process is the charge separation and collection at the interfaces. The knowledge on photovoltaic (PV) junctions can be used to tackle this challenge. In this work, the use of doped layers to enhance the electric field in an a-SiC:H photocathode, and the use of thin-film silicon multijunction devices to achieve a stand-alone solar water splitting device are discussed. Using a p-i-n structure as a-SiC:H photocathode, a current density of 10mA/cm 2 is achievable. The p-i-n structure proposed also indicates the suitability of traditional PV structures for solar water splitting.
Amorphous silicon carbide (a-SiC:H) is a promising material for photoelectrochemical water splitting owing to its relatively small band-gap energy and high chemical and optoelectrical stability. This work studies the interplay between charge-carrier separation and collection, and their injection into the electrolyte, when modifying the semiconductor/electrolyte interface. By introducing an n-doped nanocrystaline silicon oxide layer into a p-doped/intrinsic a-SiC:H photocathode, the photovoltage and photocurrent of the device can be significantly improved, reaching values higher than 0.8 V. This results from enhancing the internal electric field of the photocathode, reducing the Shockley-Read-Hall recombination at the crucial interfaces because of better charge-carrier separation. In addition, the charge-carrier injection into the electrolyte is enhanced by introducing a TiO protective layer owing to better band alignment at the interface. Finally, the photocurrent was further enhanced by tuning the absorber layer thickness, arriving at a thickness of 150 nm, after which the current saturates to 10 mA cm at 0 V vs. the reversible hydrogen electrode in a 0.2 m aqueous potassium hydrogen phthalate (KPH) electrolyte at pH 4.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.