For decades, silicon has been the material of choice for mass fabrication of electronics. This is in contrast to photonics, where passive optical components in silicon have only recently been realized. The slow progress within silicon optoelectronics, where electronic and optical functionalities can be integrated into monolithic components based on the versatile silicon platform, is due to the limited active optical properties of silicon. Recently, however, a continuous-wave Raman silicon laser was demonstrated; if an effective modulator could also be realized in silicon, data processing and transmission could potentially be performed by all-silicon electronic and optical components. Here we have discovered that a significant linear electro-optic effect is induced in silicon by breaking the crystal symmetry. The symmetry is broken by depositing a straining layer on top of a silicon waveguide, and the induced nonlinear coefficient, chi(2) approximately 15 pm V(-1), makes it possible to realize a silicon electro-optic modulator. The strain-induced linear electro-optic effect may be used to remove a bottleneck in modern computers by replacing the electronic bus with a much faster optical alternative.

Photonic Crystal Fibers (PCFs) have appeared as a new class of optical waveguides, which have attracted large scientific and commercial interest during the last years. PCFs are microstructured waveguides, usually in silica, with a large number of air holes located in the cladding region of the fiber. The size and location of these air holes opens up for a large degree of design freedom within optical waveguide design. Further, the existence of air holes in the PCF gives access close to the fiber core and by introducing new materials into the air holes, a high interaction between light and hole material can be obtained, while maintaining the microstructure of the waveguide. In this paper, we describe what we call Liquid Crystal Photonic Bandgap Fibers, which are PCFs infiltrated with Liquid Crystals (LCs) in order to obtain increased fiber functionality. We describe a thermo-optic fiber switch with an extinction ratio of 60dB and tunable PBGs using thermo-optic tuning of the LC. These devices operate by the PBG effect and are therefore highly sensitive to the refractive index distributions in the holes.

No abstract

No abstract

Abstract-Photonic crystal fibers (PCFs) offer new possibilities of realizing highly birefringent fibers due to a higher intrinsic index contrast compared to conventional fibers. In this letter, we analyze theoretically the levels of birefringence that can be expected using relatively simple PCF designs. While extremely high degrees of birefringence may be obtained for the fibers, we demonstrate that careful design with respect to multimode behavior must be performed. We further discuss the cutoff properties of birefringent PCFs and present experimental results in agreement with theoretical predictions on both single-and multimode behavior and on levels of birefringence.