No abstract

No abstract

No abstract

This work presents an optimized design of a dynamic rotor vertical-axis wind turbine (DR VAWT) which maximizes the operational tip-speed ratio (TSR) range and the average power coefficient (Cp) value while maintaining a low cut-in wind velocity. The DR VAWT is capable of mimicking a Savonius rotor during the start-up phase and transitioning into a Darrieus one with increasing rotor radius at higher TSRs. The design exploits the fact that with increasing rotor radius, the TSR value increases, where the peak power coefficient is attained. A 2.5D improved delayed detached eddy simulation (IDDES) approach was adopted in order to optimize the dynamic rotor design, where results showed that the generated blades’ trajectories can be readily replicated by simple mechanisms in reality. A thorough sensitivity analysis was conducted on the generated optimized blades’ trajectories, where results showed that they were insensitive to values of the Reynolds number. The performance of the DR VAWT turbine with its blades following different trajectories was contrasted with the optimized turbine, where the influence of the blade pitch angle was highlighted. Moreover, a cross comparison between the performance of the proposed design and that of the hybrid Savonius–Darrieus one found in the literature was carefully made. Finally, the effect of airfoil thickness on the performance of the optimized DR VAWT was thoroughly analyzed.

Numerical simulations are crucial for fast and accurate estimations of the flow characteristics in many engineering applications such as atmospheric boundary layers around buildings, external aerodynamics around vehicles, and pollutant dispersion. In the simulation of flow over urban-like obstacles, it is crucial to accurately resolve the flow characteristics with reasonable computational cost. Therefore, Large Eddy Simulations on non-uniform grids are usually employed. However, an undesirable accumulation of energy at grid-refinement interfaces was observed in previous studies using non-uniform grids. This phenomenon induced oscillations in the spanwise velocity component, mainly on fine-to-coarse grid interfaces. In this study, the two challenging test cases of flow over urban-like cubes and flow over a 3-D circular cylinder were simulated using three different scale-resolving turbulence models. Simulations were performed on uniform coarse and fine grids on one hand, and a non-uniform grid on the other, to assess the effect of mesh density and mesh interfaces on the models’ performance. Overall, the proposed One-Equation Scale-Adaptive Simulation (One-Equation SAS) showed the least deviation from the experimental results in both tested cases and on all grid sizes and types when compared to the Shear Stress Transport-Improved Delayed Detached Eddy Simulation (IDDES) and the Algebraic Wall-Modeled Large Eddy Simulation (WMLES).