Technically, a feature represents a distinguishing property, a recognizable measurement, and a functional component obtained from a section of a pattern. Extracted features are meant to minimize the loss of important information embedded in the signal. In addition, they also simplify the amount of resources needed to describe a huge set of data accurately. This is necessary to minimize the complexity of implementation, to reduce the cost of information processing, and to cancel the potential need to compress the information. More recently, a variety of methods have been widely used to extract the features from EEG signals, among these methods are time frequency distributions (TFD), fast fourier transform (FFT), eigenvector methods (EM), wavelet transform (WT), and auto regressive method (ARM), and so on. In general, the analysis of EEG signal has been the subject of several studies, because of its ability to yield an objective mode of recording brain stimulation which is widely used in brain-computer interface researches with application in medical diagnosis and rehabilitation engineering. The purposes of this paper, therefore, shall be discussing some conventional methods of EEG feature extraction methods, comparing their performances for specific task, and finally, recommending the most suitable method for feature extraction based on performance.

Electrocardiograph (ECG) compression techniques are gaining momentum due to the huge database requirements and wide band communication channels needed to maintain high quality ECG transmission. Advances in computer software and hardware enable the birth of new techniques in ECG compression, aiming at high compression rates. In general, most of the introduced ECG compression techniques depend on their evaluation performance on either inaccurate measures or measures targeting random behavior of error. In this paper, a new wavelet-based quality measure is proposed. A new wavelet-based quality measure is proposed. The new approach is based on decomposing the segment of interest into frequency bands where a weighted score is given to the band depending on its dynamic range and its diagnostic significance. A performance evaluation of the measure is conducted quantitatively and qualitatively. Comparative results with existing quality measures show that the new measure is insensitive to error variation, is accurate, and correlates very well with subjective tests.

Time-frequency wavelet theory is used for the detection of life threatening electrocardiography (ECG) arrhythmias. This is achieved through the use of the raised cosine wavelet transform (RCWT). The RCWT is found to be useful in differentiating between ventricular fibrillation, ventricular tachycardia and atrial fibrillation. Ventricular fibrillation is characterised by continuous bands in the range of 2-10 Hz; ventricular tachycardia is characterised by two distinct bands: the first band in the range of 2-5 Hz and the second in the range of 6-8 Hz; and atrial fibrillation is determined by a low frequency band in the range of 0-5 Hz. A classification algorithm is developed to classify ECG records on the basis of the computation of three parameters defined in the time-frequency plane of the wavelet transform. Furthermore, the advantage of localising and separating ECG signals from high as well as intermediate frequencies is demonstrated. The above capabilities of the wavelet technique are supported by results obtained from ECG signals obtained from normal and abnormal subjects.

Automatic detection and classification of arrhythmias based on ECG signals are important to cardiac-disease diagnostics. The ability of the ECG classifier to identify arrhythmias accurately is based on the development of robust techniques for both feature extraction and classification. A classifier is developed based on using wavelet transforms for extracting features and then using a radial basis function neural network (RBFNN) to classify the arrhythmia. Six energy descriptors are derived from the wavelet coefficients over a single-beat interval from the ECG signal. Nine different continuous and discrete wavelet transforms are considered for obtaining the feature vector. An RBFNN adapted to detect and classify life-threatening arrhythmias is then used to classify the feature vector. Classification results are based on 159 arrhythmia files obtained from three different sources. Classification results indicate the potential for wavelet based energy descriptors to distinguish the main features of the signal and thereby enhance the classification scheme. The RBFNN classifier appears to be well suited to classifying the arrhythmia, owing to the feature vectors' linear inseparability and tendency to cluster. Utilising the Daubechies wavelet transform, an overall correct classification of 97.5% is obtained, with 100% correct classification for both ventricular fibrillation and ventricular tachycardia.

Ventricular tachyarrhythmias, in particular ventricular fibrillation (VF), are the primary arrhythmic events in the majority of patients suffering from sudden cardiac death. Attention has focused upon these articular rhythms as it is recognized that prompt therapy can lead to a successful outcome. There has been considerable interest in analysis of the surface electrocardiogram (ECG) in VF centred on attempts to understand the pathophysiological processes occurring in sudden cardiac death, predicting the efficacy of therapy, and guiding the use of alternative or adjunct therapies to improve resuscitation success rates. Atrial fibrillation (AF) and ventricular tachycardia (VT) are other types of tachyarrhythmias that constitute a medical challenge. In this paper, a high order spectral analysis technique is suggested for quantitative analysis and classification of cardiac arrhythmias. The algorithm is based upon bispectral analysis techniques. The bispectrum is estimated using an autoregressive model, and the frequency support of the bispectrum is extracted as a quantitative measure to classify atrial and ventricular tachyarrhythmias. Results show a significant difference in the parameter values for different arrhythmias. Moreover, the bicoherency spectrum shows different bicoherency values for normal and tachycardia patients. In particular, the bicoherency indicates that phase coupling decreases as arrhythmia kicks in. The simplicity of the classification parameter and the obtained specificity and sensitivity of the classification scheme reveal the importance of higher order spectral analysis in the classification of life threatening arrhythmias. Further investigations and modification of the classification scheme could inherently improve the results of this technique and predict the instant of arrhythmia change.

Blindness is a state of lacking the visual perception due to physiological or neurological factors. The partial blindness represents the lack of integration in the growth of the optic nerve or visual centre of the eye, and total blindness is the full absence of the visual light perception. In this work, a simple, cheap, friendly user, smart blind guidance system is designed and implemented to improve the mobility of both blind and visually impaired people in a specific area. The proposed work includes a wearable equipment consists of head hat and mini hand stick to help the blind person to navigate alone safely and to avoid any obstacles that may be encountered, whether fixed or mobile, to prevent any possible accident. The main component of this system is the infrared sensor which is used to scan a predetermined area around blind by emitting-reflecting waves. The reflected signals received from the barrier objects are used as inputs to PIC microcontroller. The microcontroller is then used to determine the direction and distance of the objects around the blind. It also controls the peripheral components that alert the user about obstacle's shape, material, and direction. The implemented system is cheap, fast, and easy to use and an innovative affordable solution to blind and visually impaired people in third world countries.

The author proposed an effective wavelet-based ECG compression algorithm (Rajoub, 2002). The reported extraordinary performance motivated us to explore the findings and to use it in our research activity. During the implementation of the proposed algorithm several important points regarding accuracy, methodology, and coding were found to be improperly substantiated. This paper discusses these findings and provides specific subjective and objective measures that could improve the interpretation of compression results in these research-type problems.

This paper highlights a new detection method based on higher spectral analysis techniques to distinguish the Electrocardiogram (ECG) of normal healthy subjects from that with a cardiac ischaemia (CI) patient. Higher spectral analysis techniques provide in-depth information other than available conventional spectral analysis techniques usually used with ECG analysis. They provide information within frequency parts and information regarding phase associations. Bispectral analysis- Bispectrum and Quadratic Phase Coupling techniques are utilized to detect as well as to characterize phase combined harmonics in ECG. The work is developed, tested and validated using Normal Sinus Rhythm Data from the MIT-BIH Database and CI data from the ST Petersburg European ST-T Database. The results validate the efficacy of the introduced method by maintaining 100% sensitivity and achieving 93.33% positive predictive accuracy. The simplicity and robustness of the proposed method makes it feasible to be used within available ECG systems.