No abstract

No abstract

No abstract

No abstract

This paper presents the dynamic operation and control strategies of a hybrid wind-diesel-battery energy storage based power supply system for isolated communities are investigated. Control strategies for voltage and frequency stabilization and efficient power flow among the hybrid system components are developed. The voltage and frequency of the hybrid wind-diesel system is controlled either by a load side inverter or by diesel generation depending on the wind conditions. During high penetration of wind, the wind turbine supplies the required power to the load. A battery energy storage system is connected to the dc-link to balance the power generated from the wind turbine and the power demand by load. Under low wind conditions, a diesel generator is used with wind energy conversion system to generate the required power to the load. A power sharing technique is developed to allocate power generation for diesel generator in low wind conditions. Results show that the control strategies work very well under dynamic and steady state condition to supply power to the load.Index Terms-diesel generator; dump load; droop mode; isochonous mode; permanent magnet synchronous generator; power electronic converters; wind-diesel hybrid power system; wind energy conversion system.

SUMMARY This paper presents simple methods of determining parameters of interior permanent magnet (IPM) synchronous generator such as magnet flux (λM), d‐axis inductance (Ld) and q‐axis inductance (Lq) of IPM synchronous generator, which are used to control the wind turbine generator. These methods are simple and do not require any complex theory, signal injection or special equipment. Moreover, a sensorless speed estimator is proposed to estimate the speed of the generator without using speed sensor. The measured parameters are used in this speed estimator. The elimination of speed sensor will enhance the system robustness and reduce the design complexity and system cost for a small‐scale wind turbine considered in this paper. The effectiveness of parameter measurement methods and sensorless speed estimator is demonstrated by experimental results. Experimental results show that the proposed speed estimator that uses the measured parameters can estimate the generator speed with a small error. Copyright © 2014 John Wiley & Sons, Ltd.

The main purpose of developing microgrids (MGs) is to facilitate the integration of renewable energy sources (RESs) into the power grid. RESs are normally connected to the grid via power electronic inverters. As various types of RESs are increasingly being connected to the electrical power grid, power systems of the near future will have more inverter-based generators (IBGs) instead of synchronous machines. Since IBGs have significant differences in their characteristics compared to synchronous generators (SGs), particularly concerning their inertia and capability to provide reactive power, their impacts on the system dynamics are different compared to SGs. In particular, system stability analysis will require new approaches. As such, research is currently being conducted on the stability of power systems with the inclusion of IBGs. This review article is intended to be a preface to the Special Issue on Voltage Stability of Microgrids in Power Systems. It presents a comprehensive review of the literature on voltage stability of power systems with a relatively high percentage of IBGs in the generation mix of the system. As the research is developing rapidly in this field, it is understood that by the time that this article is published, and further in the future, there will be many more new developments in this area. Certainly, other articles in this special issue will highlight some other important aspects of the voltage stability of microgrids.

No abstract