Hierarchical semicrystalline block copolymer nanoparticles are produced in a segmented gas-liquid microfluidic reactor with top-down control of multiscale structural features, including nanoparticle morphologies, sizes, and internal crystallinities. Control of multiscale structure on disparate length scales by a single control variable (flow rate) enables tailoring of drug delivery nanoparticle function including release rates.

We demonstrate control of multiscale structure and drug delivery function for paclitaxel (PAX)-loaded polycaprolactone-block-poly(ethylene oxide) (PCL-b-PEO) polymeric nanoparticles (PNPs) via synthesis and flow-directed shear processing in a two-phase gas-liquid microfluidic reactor. This strategy takes a page from the engineering of commodity plastics, where processing rather than polymer chemistry provides an experimental handle on properties and function. PNPs formed from copolymers with three different PCL block lengths show sizes, morphologies, and loading efficiencies that depend on both the PCL block length and the microfluidic flow rate. By varying flow rate and comparing with a conventional bulk method of PNP preparation, we show that flow-variable shear processing provides control of PNP sizes and morphologies and enables slower PAX release times (up to 2 weeks) compared to bulk-prepared PNPs. Antiproliferative effects against cultured MCF-7 breast cancer cells were greatest for PNPs formed at an intermediate flow rate, corresponding to small and low-polydispersity spheres formed uniquely at this flow condition. Formation and flow-directed nanoscale shear processing in gas-liquid microfluidic reactors provides a manufacturing platform for drug delivery PNPs that could enable more effective and selective nanomedicines through multiscale structural control.

We demonstrate a microfluidic approach to the production of block copolymer vesicles via flow-directed self-assembly in a segmented gas-liquid device. Chemical conditions that favor spherical micelles in the bulk are found to yield a nearly pure population of vesicles on a chip-a transformation of two full morphological steps-because of a coalescence mechanism enabled by high shear. The production of polymeric vesicles via top-down control in a microfluidic device enables new processing routes to applications including drug delivery formulations in the lab-on-a-chip.

No abstract

We investigate the loading efficiencies of two chemically distinct hydrophobic fluorescent probes, pyrene and naphthalene, for self-assembly and loading of polystyrene-block-poly(acrylic acid) (PS-b-PAA) micelles in gas-liquid segmented microfluidic reactors under different chemical and flow conditions. On-chip loading efficiencies are compared to values obtained via off-chip dropwise water addition to a solution of copolymer and probe. On-chip, probe loading efficiencies depend strongly on the chemical probe, initial solvent, water content, and flow rate. For pyrene and naphthalene probes, maximum on-chip loading efficiencies of 73 ± 6% and 11 ± 3%, respectively, are obtained, in both cases using the more polar solvent (DMF), an intermediate water content (2 wt % above critical), and a low flow rate (∼5 μL/min); these values are compared to 81 ± 6% and 48 ± 2%, respectively, for off-chip loading. On-chip loading shows a significant improvement over the off-chip process where shear-induced formation of smaller micelles enables increased encapsulation of probe. As well, we show that on-chip loading allows off-chip release kinetics to be controlled via flow rate: compared to vehicles produced at ∼5 μL/min, pyrene release kinetics from vehicles produced at ∼50 μL/min showed a longer initial period of burst release, followed by slow release over a longer total period. These results demonstrate the necessity to match probes, solvents, and running conditions to achieve effective loading, which is essential information for further developing these on-chip platforms for manufacturing drug delivery formulations.