We report here the chemical modification of poly(methyl methacrylate) (PMMA) surfaces by their reaction with the monoanion of alpha,omega-diaminoalkanes (aminolysis reaction) to yield amine-terminated PMMA surfaces. It is found that the amine functionalities are tethered to the PMMA backbone through an alkane bridge to amide bonds formed during the aminolysis of the surface ester functionalities. The distribution of the amine termini is quite uniform as judged by fluorescence micrographs. It is found that the electroosmotic flow in aminated PMMA microchannels is reversed when compared to that in unmodified channels. In addition, it is demonstrated that enzymes can be immobilized onto the amine-terminated PMMA surfaces and are effective in the restriction digestion of dsDNAs. Finally, the availability of the surface amine groups is further demonstrated by their reaction with n-octadecane-1-isocyanate to form PMMA surfaces terminated with well-ordered and highly crystalline octadecane chains.

An on-column contact conductivity detector was developed for the analysis of various mono- and polyanionic compounds separated by electrophoresis chips fabricated in poly(methyl methacrylate) (PMMA) using hot embossing techniques from Ni electroforms. The detector consisted of a pair of Pt wires (127 microm diameter) with an end-to-end spacing of approximately 20 microm and situated within the fluidic channel. The waveform applied to the electrode pair was a bipolar pulse with a frequency of 5.0 kHz and was used to reduce the charging current from measurement so that the current recorded at the end of one pulse is more representative of the solution conductivity. Using the detector, separations of amino acids, peptides, proteins, and oligonucleotides were demonstrated. For the amino acids and peptides, free-solution zone electrophoresis was performed. A calibration plot for the amino acid alanine was found to be linear from approximately 10 to 100 nM in a carrier electrolyte consisting of 10 mM triethylamonium acetate. The concentration detection limit was found to be 8.0 nM, with the corresponding mass detection limit equal to 3.4 amol (injection volume = 425 pL). The protein separations with conductivity detection were performed using MEKC, in which the carrier electrolyte contained the anionic surfactant sodium dodecyl sulfate (SDS) above its cmc. Near baseline resolution was achieved in the PMMA microchip for a solution containing 8 different proteins. In the case of the DNA fragments, capillary electrochromatography was used with a C18-modified PMMA chip and a carrier electrolyte containing an ion-pairing agent.

No abstract

Ultrasensitive, near-infrared (NIR), time-resolved fluorescence is evaluated as a detection method for reading DNA hybridization events on solid surfaces for microarray applications. In addition, the potential of mulitiplexed analyses using time-resolved identification protocols is described. To carry out this work, a NIR time-resolved confocal imager was constructed to read fluorescence signatures from the arrays. The device utilized a 780-nm pulsed diode laser, a single-photon avalanche diode (SPAD), and a high-numerical-aperture microscope objective mounted in an epi-illumination format. Due to the small size of the components that are required to construct this imager, the entire detector could easily be mounted on high-resolution translational stages and scanned over the stationary arrays. The instrument response function of the device was determined to be 275 ps (fwhm), which is adequate for measuring fluorophores with subnanosecond lifetimes. To characterize the system, NIR dyes were deposited directly on different substrate materials typically used for DNA microarrays, and the fluorescence lifetimes of two representative dyes were measured. The fluorescence lifetime for aluminum tetrasulfonated naphthalocyanine was found to be 1.92 ns, and a value of 1.21 ns was determined for the tricarbocyanine dye, IRD800, when it was deposited onto poly(methyl methacrylate) (PMMA) and measured in the dry state. Finally, the imager was used to monitor hybridization events using probe oligonucleotides chemically tethered to a PMMA substrate via a glutardialdehyde linkage to an aminated-PMMA surface. The limit of detection for oligonucleotides containing a NIR fluorescent reporter was determined to be 0.38 molecules/microm2, with this detection limit improving by a factor of 10 when a time-gate was implemented. Fluorescence lifetime analysis of the hybridization events on PMMA indicated a lifetime value of 1.23 ns for the NIR-labeled oligonucleotides when using maximum-likelihood estimators.

Sample-in answer-out analytical tools remain the goal of much lab on a chip research, but miniaturized methods capable of examining minimally prepared samples have proven elusive. Complex samples, including whole milk, various types of dirt and leaves, coal fly ash, and blood serum, were analyzed quantitatively for dissolved potassium, calcium, sodium, magnesium, lithium, and melamine using gradient elution moving boundary electrophoresis (GEMBE) and contactless conductivity detection with the single preparatory step of dilution or suspension in sample buffer. GEMBE is a simple, robust analytical technique, well-suited to microfluidic analysis of complex samples containing material, such as particulates or proteins, that would confound the majority of other microfluidic techniques. GEMBE utilizes electrophoretic flow to drive electrically charged analytes into a microfluidic channel or capillary for detection, while opposing electro-osmotic and variable pressure-driven flows prevent the remainder of the sample from entering the channel. Contactless conductivity detection further simplifies device construction and operation, positioning GEMBE for inexpensive and facile multiplexed implementation outside laboratory settings.