No abstract

No abstract

Since stringers are often applied in engineering constructions to improve thin-walled structures’ strength, methods for damage detection at the joints between the stringer and the thin-walled structure are necessary. A 2D mathematical model was employed to simulate Lamb wave excitation and sensing via rectangular piezoelectric-wafer active transducers mounted on the surface of an elastic plate with rectangular surface-bonded obstacles (stiffeners) with interface defects. The results of a 2D simulation using the finite element method and the semi-analytical hybrid approach were validated experimentally using laser Doppler vibrometry for fully bonded and semi-debonded rectangular obstacles. A numerical analysis of fundamental Lamb wave scattering via rectangular stiffeners in different bonding states is presented. Two kinds of interfacial defects between the stiffener and the plate are considered: the partial degradation of the adhesive at the interface and an open crack. Damage indices calculated using the data obtained from a sensor are analyzed numerically. The choice of an input impulse function applied at the piezoelectric actuator is discussed from the perspective of the development of guided-wave-based structural health monitoring techniques for damage detection.

A novel kind of acoustic metamaterials (AMMs) with unit cells composed of two layers made of dissimilar materials with a crack-like void situated at the interface between bars is considered. Recently, the authors showed numerically that this novel kind of AMMs can provide unidirectional propagation of guided waves. Several AMM specimens (the finite stack of periodic elastic layers with and without voids) have been manufactured using additive manufacturing techniques and regular gluing. The details of the manufacturing process are discussed. In the experiment, the elastic waves have been excited by a rectangular piezoelectric wafer active transducer bonded at the surface of the specimen. Vibrations of the opposite side of the AMM specimen are measured via a piezoelectric sensor. The band gaps are observed in the experiment and values of their width and location correlate with numerically predicted ones.

The paper proposes a new hybrid approach technique to simulate acousto-ultrasonic wave excitation and propagation due to operation of the partially debonded piezoelectric transducer attached to a plate-like structure. The semi-analytical boundary integral equation method is applied to calculate guided waves propagation in the unbounded structures and to separate different guided waves in the piezo-induced wave-fields. The obtained model is verified experimentally using the scanning laser Doppler vibrometry. Eigenfrequencies are calculated and analysed for various sizes of the transducer and for different bonding conditions between the transducer and the waveguide. The impact of the transducer’s height, size and debonding area on symmetric and antisymmetric Lamb waves excitation is analysed. The paper demonstrates that one-sided debonding of the transducer exerts intense influence on the distribution of the wave energy among the excited Lamb wave modes, while center debonding has a sizable impact only at relatively high frequencies.