The aim of this study was to evaluate concentration-dependent antioxidant and anticancer activities of CA and RA in ethanol extracts of three different Oregano species (Origanum onites L., Origanum vulgare L., and Origanum vulgare ssp. hirtum). The study revealed the highest RA antioxidant activity in O. vulgare ssp. hirtum (9550 ± 95 mmol/g) and the lowest in O. vulgare L. (2605 ± 52 mmol/g) (p < 0.05). The highest CA amount was present in O. onites L., which was 1.8 and 4.7 times higher (p < 0.05) than in O. vulgare ssp. hirtum and O. vulgare L., respectively. The anticancer activity was evaluated on human glioblastoma (U87) and triple-negative breast cancer (MDA-MB231) cell lines in vitro. RA anticancer activity was negligible. CA and the extracts were about 1.5–2 times more active against MDA-MB231 cell line (p < 0.05) compared to U87 cell line. The anticancer activities of three tested extracts were similar against U87 cell line (p > 0.05) but they had different activities against MDA-MB231 cell line.

The aim of this study was optimization of spray-drying process conditions for microencapsulation of Turkish oregano extract. Different concentrations of maltodextrin and gum arabic as encapsulating agents (wall material) as well as influence of selected processing variables were evaluated. The optimal conditions were maintained on the basis of the load of main bioactive compounds - ursolic, rosmarinic acids and carvacrol - in prepared microparticles after comparison of all significant response variables using desirability function. Physicomechanical properties of powders such as flowability, wettability, solubility, moisture content as well as product yield, encapsulation efficiency (EE), density, morphology and size distribution of prepared microparticles have been determined. The results demonstrated that the optimal conditions for spray-drying mixture consisted of two parts of wall material solution and one part of ethanolic oregano extract when the feed flow rate was 40 mL/min and air inlet temperature -170 °C. Optimal concentration of wall materials in solution was 20% while the ratio of maltodextrin and gum arabic was 8.74:1.26.

The potential antimicrobial benefit of high levels of rosmarinic acid (RA) and carvacrol (CA) in oregano (O. onites L.) extract has been limited until now by poor bioavailability arising from the low aqueous-phase solubility and slow dissolution behaviour of the lyophilized extract (E). To address this issue, various ratios of phospholipon 90H (P90H) and 1,2-dimyristoyl-sn-glycero-3-phospho-(1'-rac-glycerol), sodium salt (DMPG) were sonicated, yielding four empty liposomes (L1, L2, L3, and L90). After an initial selection process, Turkish oregano extract was internalized into the more promising candidates. Each empty liposome, extract-loaded liposome (LE1, LE2, and LE3), and freeze-dried control (E) was assessed in terms of structure, composition, RA and CA dissolution profile, storage stability, and, when relevant, zeta potential. Empty liposome L1, which was prepared using P90H and DMPG in a 1:1 ratio, displayed the most convenient encapsulation traits among the four unloaded types. Loaded liposome LE1, obtained by combining oregano extract and L1 in a 1:1 ratio, proved superior as a vehicle to deliver RA & CA when compared against control freeze-dried E and test liposomes LE2 and LE3. Dissolution profiles of the active compounds RA and CA in loaded liposomes were determined using a semi-automated dissolution tester. The basket method was applied using artificial gastric juice without pepsin (AGJ, 50rpm, 500mL). The pH value was maintained at 1.5 (37 ± 0.5°C). Aliquots (5ml) were manually extracted from parallel dissolution vessels at 1, 3, 5, 7, 10, 15, 20, 25, 30, 45, and 60-minute time points. Dissolution tests, run to completion on LE1, showed that approximately 99% of loaded CA and 88% of RA had been released. Shorter dissolution times were also noted in using LE1. In particular, the release profile of CA and RA had levelled off after only 25 minutes, respectively, depicting an impressive 3.0–3.3 and 2.3-2.6 rate increase compared to the freeze-dried control extract. The improved dispersibility of RA and CA in the form of LE1 was supported by particle size and zeta potential measurements of the liposome, yielding 234.3nm and −30.9mV, respectively. The polydispersity index value was 0.35, indicating a reasonable particle size distribution. To study storage stability, liposomes were stored (4°C, 6 months) in amber coloured glass containers (4 oz.). Each container held 30 capsules, which were stored according to the ICH guidelines prescribed for long-term storage (25°C ± 2°C; 60% ± 5% RH). Triplicate samples were withdrawn after 0, 3, 6, 9, and 12 months for analysis. Lastly, LE1 displayed good storage stability. The results imply that RA and CA can be conveniently and routinely delivered via oral and mucosal routes by first internalizing oregano extracts into appropriately engineered liposomes.

Introduction Nowadays, the interest in industrial Cannabis sativa L. herb has been increasing in the world. As a result, it is becoming one of the most studied plants due to its multifunctional benefits. Objectives To the best of our knowledge, no study has been conducted so far to determine the impact of extraction methods and conditions on the extraction yields of CBD and CBG from the Cannabis sativa L. ssp. Santhica. Therefore, we aimed to investigate a simple and sensitive GC‐FID method to determine CBD and CBG in hemp extract. Methods As regards sample preparation, three extraction techniques were compared, including maceration (ME), ultrasound‐assisted extraction (UAE) and reflux‐heat extraction (RHE), in order to obtain a high recovery of the CBD of interest from the plant material. The GC‐FID method developed in this study represents a powerful tool for the extraction and analysis of non‐psychoactive cannabinoids from hemp varieties to be used for the preparations of extracts with a high content of bioactive compounds for both pharmaceutical and nutraceutical applications. Results A simple extraction procedure for CBD and CBG from hemp was also optimized in this work, by using ultrasound assisted extraction method with 96% ethanol, material/solvent ratio 1:10 and extraction time 10 min at room temperature. Conclusion The overall analytical method was fully validated in agreement with international guidelines. Therefore, proving a powerful and reliable tool for both the selection of hemp varieties with a high content of bioactive compounds and the quality control of its derivatives.

Summary. Phenolic acids and phenylpropanoids have an important biological activity and