No abstract

The graft can be retained during treatment of septic arthritis after anterior cruciate ligament reconstruction.

Purpose Reverse shoulder prostheses have been gaining popularity in recent years. A short metaphyseal stem design will allow bone stock preservation and minimize stem related complications. We examined the clinical and radiographic short-term outcome of a short metaphyseal stem reverse shoulder arthroplasty. Methods Thirty-one patients, with a mean follow-up of 36 months (24-52), were evaluated clinically with the Constant-Murley score, patient satisfaction and pain relief scores. The fixation of the glenoid and humeral components, subsidence and notching were evaluated on radiographs. The indications were cuff tear arthropathy (22), fracture sequelae (five) and rheumatoid arthritis (four). Results The average Constant score improved from 12.7 (range two to 31) pre-operatively to 56.2 (range 17-86) postoperatively. It rose from 13.5 to 58.3 in patients with Cuff arthropathy, from 15.8 to 62.0 in revision arthroplasty, from 10.2 to 47.4 in those with fracture sequelae, and from 11.5 to 55.3 in patients with rheumatoid arthritis. The overall mean patient satisfaction score improved from 2.4/10 to 8.5/10 and mean pain score improved from 0.8/15 to 12.5/15. We found an overall improvement in active forward flexion from 46.8 to 128.5°and from 41.6 to 116.5°in abduction. No humeral loosening or subsidence was observed. Two cases of grade 1-2 glenoid notching were reported. Overall there were three intra-operative fractures that did not affect the operation and healed without affecting the good results. There were five late traumatic periprosthetic fractures, only one of them required a revision surgery to a stemmed implant and the rest healed without surgery. There were two early dislocations that had to be revised. Conclusions The clinical and radiographic evaluation of a bone preserving metaphyseal humeral component in reverse shoulder arthroplasty is promising, with good clinical results, no signs of loosening or subsidence.

No abstract

De Quervain's disease has different clinical features. Different tests have been described in the past, the most popular test being the Eichhoff's test, often wrongly named as the Finkelstein's test. Over the years, a misinterpretation has occurred between these two tests, the latter being confused with the first. To compare the Eichhoff's test with a new test, the wrist hyperflexion and abduction of the thumb test, we set up a prospective study over a period of three years for a cohort of 100 patients (88 women, 12 men) presenting spontaneous pain over the radial side of the styloid of the radius (de Quervain tendinopathy). The purpose of the study was to compare the accuracy of the Eichhoff's test and wrist hyperflexion and abduction of the thumb test to diagnose correctly de Quervain's disease by comparing clinical findings using those tests with the results on ultrasound. The wrist hyperflexion and abduction of the thumb test revealed greater sensitivity (0.99) and an improved specificity (0.29) together with a slightly better positive predictive value (0.95) and an improved negative predictive value (0.67). Moreover, the study showed us that the wrist hyperflexion and abduction of the thumb test is very valuable in diagnosing dynamic instability after successful decompression of the first extensor compartment. Our results support that the wrist hyperflexion and abduction of the thumb test is a more precise tool for the diagnosis of de Quervain's disease than the Eichhoff's test and thus could be adopted to guide clinical diagnosis in the early stages of de Quervain's tendinopathy.

For surgical treatment to be successful, the instability must be attributable to mechanical factors that can be modified by surgery. Because of better knowledge of the pathology, a more specific surgery can be performed. This lesion-specific surgery has improved clinical results compared to non-anatomic stability procedures, particularly when that surgery has been performed arthroscopically.

Insufficient glenoid fixation is one of the main reasons for failure in total shoulder arthroplasty. This is predominantly caused by the inert nature of the ultra-high molecular weight polyethylene (UHMWPE) used in the glenoid component of the implant, which makes it difficult to adhesively bind to bone cement or bone. Previous studies have shown that this adhesion can be ameliorated by changing the surface chemistry using plasma technology. An atmospheric pressure plasma jet is used to treat UHMWPE substrates and to modify their surface chemistry. The modifications are investigated using several surface analysis techniques. The adhesion with bone cement is assessed using pull-out tests while osteoblast adhesion and proliferation is also tested making use of several cell viability assays. Additionally, the treated samples are put in simulated body fluid and the resulting calcium phosphate (CaP) deposition is evaluated as a measure of the in vitro bioactivity of the samples. The results show that the plasma modifications result in incorporation of oxygen in the surface, which leads to a significant improved adhesion to bone cement, an enhanced osteoblast proliferation and a more pronounced CaP deposition. The plasma-treated surfaces are therefore promising to act as a shoulder implant.

Graft non-union resulting in recurrent instability was the main indication for open revision surgery after Bristow or Latarjet procedure, followed by resorption, malpositioning, and graft fracture in this retrospective case series. Revision surgery consisted of a structural iliac crest bone graft in the majority of cases. Clinical and radiographic outcomes are predictably variable in this population of multioperated patients.