The UGent Institutional Repository is the electronic archiving and dissemination platform for all UGent research publications. Ghent University has implemented a mandate stipulating that all academic publications of UGent researchers should be deposited and archived in this repository. Except for items where current copyright restrictions apply, these papers are available in Open Access. This item is the archived peer-reviewed author-version of: A multivariate approach to predict the volumetric and gravimetric feeding behavior of a low feed rate feeder based on raw material properties

The drying unit of a continuous from-powder-to-tablet manufacturing line based on twin-screw granulation (TSG) is a crucial intermediate process step to achieve the desired tablet quality. Understanding the size reduction of pharmaceutical granules before, during, and after the fluid bed drying process is, however, still lacking. A first major goal was to investigate the breakage and attrition phenomena during transport of wet and dry granules, the filling phase, and drying phase on a ConsiGma-25 system (C25). Pneumatic transport of the wet granules after TSG towards the dryer induced extensive breakage, whereas the turbulent filling and drying phase of the drying cells caused rather moderate breakage and attrition. Subsequently, the dry transfer line was responsible for additional extensive breakage and attrition. The second major goal was to compare the influence of drying air temperature and drying time on granule size and moisture content for granules processed with a commercial-scale ConsiGma-25 system and with the R&D-scale ConsiGma-1 (C1) system. Generally, the granule quality obtained after drying with C1 was not predictive for the C25, making it challenging during process development with the C1 to obtain representative granules for the C25.

No abstract

No abstract

No abstract

Toward further implementation of continuous tablet manufacturing, one key issue is the time needed for start-up operation because it could lead to lower product yield and reduced economic performance. The behavior of the start-up operation is not well understood; moreover, the definition of the start-up time is still unclear. This work investigates the effects of process parameters on the start-up operation in continuous wet granulation, which is a critical unit operation in solid drug manufacturing. The profiles of torque and granule size distribution were monitored and measured for the first hour of operation, including the start-up phase. We analyzed the impact of process parameters based on design of experiments and performed an economic assessment to see the effects of the start-up operation. The torque profiles indicated that liquid-to-solid ratio and screw speed would affect the start-up operation, whereas different start-up behavior resulted in different granule size. Depending on the indicator used to define the start-up operation, the economic optimal point was significantly different. The results of this study stress that the start-up time differs according to the process parameters and used definition, e.g., indicators and criteria. This aspect should be considered for the further study and regulation of continuous manufacturing.

No abstract

No abstract