Leveraging the advantageous material properties of recently developed soft thermoplastic elastomer materials, this work presents the facile and rapid fabrication of composite membrane-integrated microfluidic devices consisting of FlexdymTM polymer and commercially available porous polycarbonate membranes. The three-layer devices can be fabricated in under 2.5 h, consisting of a 2-min hot embossing cycle, conformal contact between device layers and a low-temperature baking step. The strength of the FlexdymTM-polycarbonate seal was characterized using a specialized microfluidic delamination device and an automated pressure controller configuration, offering a standardized and high-throughput method of microfluidic burst testing. Given a minimum bonding distance of 200 μm, the materials showed bonding that reliably withstood pressures of 500 mbar and above, which is sufficient for most microfluidic cell culture applications. Bonding was also stable when subjected to long term pressurization (10 h) and repeated use (10,000 pressure cycles). Cell culture trials confirmed good cell adhesion and sustained culture of human dermal fibroblasts on a polycarbonate membrane inside the device channels over the course of one week. In comparison to existing porous membrane-based microfluidic platforms of this configuration, most often made of polydimethylsiloxane (PDMS), these devices offer a streamlined fabrication methodology with materials having favourable properties for cell culture applications and the potential for implementation in barrier model organ-on-chips.
A novel fluorinated soft thermoplastic elastomer (sTPE) for microfluidics is presented. It allows the rapid fabrication of microfluidic devices through a 30‐second hot embossing cycle at 220°C followed by self‐sealing through simple conformal contact at room temperature, or with baking. The material shows high chemical resistance, particularly in comparison to polydimethylsiloxane (PDMS), to many common organic solvents and can be rapidly micropatterned with high fidelity using a variety of microfluidic master molds thanks to its low mechanical stiffness. Self‐sealing of the material is reversible and withstands pressures of up to 2.8 bar with room temperature sealing and four bar with baking at 185°C for 2 hours. The elastomeric, transparent sTPE exhibits material characteristics that make it suited for use as a microreactor, such as low absorption, surface roughness and oxygen permeability, while also allowing a facile and scalable fabrication process. Modular microfluidic devices, leveraging the fast and reversible room temperature self‐sealing, are demonstrated for the generation of water droplets in a toluene continuous phase using T‐junctions of variable size. The sTPE offers an alternative to common microfluidic materials, overcoming some of their key drawbacks, and giving scope for low‐cost and high‐throughput devices for flow chemistry applications.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.